Scribd
Upload
37 views

Culvert Sheet

This document provides data to design a reinforced concrete box culvert under a roadway to pass a canal, including dimensions of the canal and road, soil properties, allowable headwater and minimum submergence, and required design drawings. The culvert design needs to meet requirements of checking the heading up is within limits, drawing bending moment and normal force diagrams for critical sections, and providing plan, section, and reinforcement drawings to scale.

Uploaded by

Saif Ashraf
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
37 views

Culvert Sheet

This document provides data to design a reinforced concrete box culvert under a roadway to pass a canal, including dimensions of the canal and road, soil properties, allowable headwater and minimum submergence, and required design drawings. The culvert design needs to meet requirements of checking the heading up is within limits, drawing bending moment and normal force diagrams for critical sections, and providing plan, section, and reinforcement drawings to scale.

Uploaded by

Saif Ashraf
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Mansoura University Design of Irrigation Works (I)

Faculty of Engineering 3rd Year Civil Engineering


Irrigation & Hydraulics Eng. Dept 1st Term 2020-2021

CULVERT

It is required to design the culvert proposed to pass the canal under the
roadway according the following data:-
CANAL
• Bed level = (10.00), Bed width = 4.50 m
• Berm level = (13.50), Bank level = (14.25)
• W.L = (12.70),
• Canal discharge = 10.30 m3/sec,
• sides slopes are 1:1 and 3:2

ROAD
• Road width = 8.0 m
• Road side slopes = 3:2
• Uniform distributed L.L = 1t/m2
CULVERT
• Allowable heading up = 10.0 cm
• U.S min submersion = 10.0 cm
• Use R.C box-type section.

SOIL
• Dry unite weight = 1.80 t/m3
• Saturated unite weight = 2.1 t/m3
• Angle of internal friction = 30o

REQUIREMENTS
1. Find the dimensions of culvert and check of heading up
2. Draw the absolute B.M and N.F diagrams for the critical sections of
the culvert and make the necessary R.C design.
3. Draw to scale 1:100
1. P.H.E.R (Plan Half Earth Remove).
2. Longitudinal section elevation (lower vent).
3. Reinforcement details of the culvert section.

You might also like