Scribd
Upload
712 views2 pages

10.4.3 Packet Tracer - Basic Device Configuration PDF

Uploaded by

Gaille Anne
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
712 views2 pages

10.4.3 Packet Tracer - Basic Device Configuration PDF

Uploaded by

Gaille Anne
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Packet Tracer - Basic Device Configuration

Topology
You will receive one of three possible topologies.

Addressing Table
Device Interface IP Address Default Gateway

blank G0/0 blank N/A


blank N/A
G0/0
blank N/A
G0/0
G0/1 blank N/A
blank N/A
G0/1
blank N/A
G0/1
blank VLAN 1 blank blank

blank VLAN 1 blank blank


blank NIC blank blank

NIC blank blank

blank NIC blank blank

NIC blank blank

blank NIC blank blank

NIC blank blank


blank NIC blank blank

NIC blank blank

Objectives
• Complete the network documentation.
• Perform basic device configurations on a router and a switch.
• Verify connectivity and troubleshoot any issues.

Scenario
Your network manager is impressed with your performance in your job as a LAN technician. She would like
you to demonstrate your ability to configure a router that connects two LANs. Your tasks include configuring
basic settings on a router and a switch using the Cisco IOS. You will also configure IPv6 addresses on
network devices and hosts. You will then verify the configurations by testing end-to-end connectivity. You goal
is to establish connectivity between all devices.

© 2013 - 2019 Cisco and/or its affiliates. All rights reserved. Cisco Public Page 1 of 2 www.netacad.com
Packet Tracer - Basic Device Configuration

Note: The VLAN1 interface on will not be reachable over IPv6.


In this activity you will configure the router, switch, and the PC hosts.
Note: Packet Tracer will not score some configured values, however these values are required to accomplish
full connectivity in the network.

Requirements
• Provide the missing information in the Addressing Table.
• Name the router and the second switch . You will not be able to access
the switch.
• Use cisco as the user EXEC password for all lines.
• Use class as the encrypted privileged EXEC password.
• Encrypt all plaintext passwords.
• Configure an appropriate banner.
• Configure IPv4 and IPv6 addressing for the switch according to the Addressing Table.
• Configure IPv4 and IPv6 addressing for the switch according to the Addressing Table.
• The hosts are partially configured. Complete the IPv4 addressing, and fully configure the IPv6 addresses
according to the Addressing Table.
• Document interfaces with descriptions, including the VLAN 1 interface.
• Save your configurations.
• Verify connectivity between all devices. All devices should be able to ping all other devices with IPv4 and
IPv6.
• Troubleshoot and document any issues.
• Implement the solutions necessary to enable and verify full end-to-end connectivity.
Note: Click Check Results button to see your progress. Click the Reset Activity button to generate a new
set of requirements.
End of document

© 2013 - 2019 Cisco and/or its affiliates. All rights reserved. Cisco Public Page 2 of 2 www.netacad.com

You might also like