Scribd
Upload
37 views

Common Data For Q. - 24 and Q.26: 20 KW 5 MM 19 MM

This document contains sample questions from a machine design chapter of a mechanical engineering textbook. It includes 29 multiple choice questions regarding gears, clutches, shafts, and endurance strength. The questions cover topics like gear ratios, center distances, contact ratios, torque calculations, clutch sizing, and fatigue life estimation. Common data is provided for some related questions. The document also provides publishing information for the book at the end.

Uploaded by

SameerChauhan
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
37 views

Common Data For Q. - 24 and Q.26: 20 KW 5 MM 19 MM

This document contains sample questions from a machine design chapter of a mechanical engineering textbook. It includes 29 multiple choice questions regarding gears, clutches, shafts, and endurance strength. The questions cover topics like gear ratios, center distances, contact ratios, torque calculations, clutch sizing, and fatigue life estimation. Common data is provided for some related questions. The document also provides publishing information for the book at the end.

Uploaded by

SameerChauhan
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

www.gatehelp.

com

CHAP 5 MACHINE DESIGN PAGE 219

of safety for the piston rod is


(A) 0.68 (B) 2.75
(C) 5.62 (D) 11.0

• Common Data For Q.24 and Q.26


A gear set has a pinion with 20 teeth and a gear with 40 teeth. The pinion
runs at 30 rev/s and transmits a power of 20 kW. The teeth are on the 20c
full-depth system and have a module of 5 mm. The length of the line of
action is 19 mm.
MCQ 5.24 The center distance for the above gear set in mm is
(A) 140 (B) 150
(C) 160 (D) 170

MCQ 5.25 The contact ratio of the contacting tooth is


(A) 1.21 (B) 1.25
(C) 1.29 (D) 1.33

MCQ 5.26 The resultant force on the contacting gear tooth in N is


(A) 77.23 (B) 212.20
(C) 2258.1 (D) 289.43

YEAR 2006 TWO MARKS

MCQ 5.27 A disc clutch is required to transmit 5 kW at 2000 rpm. The disk has a
friction lining with coefficient of friction equal to 0.25. Bore radius of friction
lining is equal to 25 mm. Assume uniform contact pressure of 1 MPa. The
value of outside radius of the friction lining is
(A) 39.4 mm (B) 49.5 mm
(C) 97.9 mm (D) 142.9 mm

MCQ 5.28 Twenty degree full depth involute profiled 19 tooth pinion and 37 tooth gear
are in mesh. If the module is 5 mm, the centre distance between the gear
pair will be
(A) 140 mm (B) 150 mm
(C) 280 mm (D) 300 mm

MCQ 5.29 A cylindrical shaft is subjected to an alternating stress of 100 MPa. Fatigue
strength to sustain 1000 cycles is 490 MPa. If the corrected endurance
strength is 70 MPa, estimated shaft life will be
(A) 1071 cycles (B) 15000 cycles

GATE Previous Year Solved Paper For Mechanical Engineering


Published by: NODIA and COMPANY ISBN: 9788192276250
Visit us at: www.nodia.co.in

You might also like