Scribd
Upload
20 views

Manufacturing Engineering-34

The document contains 3 multiple choice questions about manufacturing engineering topics: 1) A question about heat generated during resistance spot welding of two 1.5mm plates with a 6mm diameter electrode using 15000A current for 0.25s. 2) A question about how many degrees of freedom a workpiece is restricted by a 3-2-1 method of location in a jig or fixture. 3) A question about the correct G and N codes to move a tool along a circular path from point (5,4) to (7,2) with center at (5,2) in an NC machining operation.

Uploaded by

SameerChauhan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
20 views

Manufacturing Engineering-34

The document contains 3 multiple choice questions about manufacturing engineering topics: 1) A question about heat generated during resistance spot welding of two 1.5mm plates with a 6mm diameter electrode using 15000A current for 0.25s. 2) A question about how many degrees of freedom a workpiece is restricted by a 3-2-1 method of location in a jig or fixture. 3) A question about the correct G and N codes to move a tool along a circular path from point (5,4) to (7,2) with center at (5,2) in an NC machining operation.

Uploaded by

SameerChauhan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

www.gatehelp.

com

PAGE 460 MANUFACTURING ENGINEERING CHAP 10

MCQ 10.163 Resistance spot welding is performed on two plates of 1.5 mm thickness with
6 mmdiameter electrode, using 15000 A current for a time duration of 0.25 s
. Assuming the interface resistance to be 0.0001 Ω, the heat generated to
form the weld is
(A) 5625 W −s (B) 8437 W −s
(C) 22500 W −s (D) 33750 W −s

MCQ 10.164 3-2-1 method of location in a jig or fixture would collectively restrict the
work piece in n degrees of freedom, where the value of n is
(A) 6 (B) 8
(C) 9 (D) 12

MCQ 10.165 In an NC machining operation, the tool has to be moved from point (5, 4)
to point (7, 2) along a circular path with centre at (5, 2). Before starting the
operation, the tool is at (5, 4). The correct G and N codes for this motion
are
(A) N010 GO 3 X 7.0 Y2.0 I 5.0 J 2.0
(B) N010 GO 2 X 7.0 Y 2.0 I 5.0 J 2.0
(C) N010 GO1 X 7.0 Y 2.0 I 5.0 J 2.0
(D) N010 GOO X 7.0 Y 2.0 I 5.0 J 2.0

************

GATE Previous Year Solved Paper For Mechanical Engineering


Published by: NODIA and COMPANY ISBN: 9788192276250
Visit us at: www.nodia.co.in

You might also like