Scribd
Upload
341 views3 pages

Design Calculation of Worm

The document provides design calculations for a worm gear. It lists key parameters such as normal pressure angle, power transmitted, speeds of the worm and gear, velocity ratio, and center distance. It then describes design aspects of the worm including lead angle, normal lead, axial lead, number of starts, axial and normal pitches, module, center distance, pitch diameter, number of teeth, face length, tooth depth, addendum, outside diameter, and diameter factor. Values for each parameter are provided.

Uploaded by

Venkateswaran venkateswaran
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
341 views3 pages

Design Calculation of Worm

The document provides design calculations for a worm gear. It lists key parameters such as normal pressure angle, power transmitted, speeds of the worm and gear, velocity ratio, and center distance. It then describes design aspects of the worm including lead angle, normal lead, axial lead, number of starts, axial and normal pitches, module, center distance, pitch diameter, number of teeth, face length, tooth depth, addendum, outside diameter, and diameter factor. Values for each parameter are provided.

Uploaded by

Venkateswaran venkateswaran
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLS, PDF, TXT or read online on Scribd
You are on page 1/ 3

DESIGN CLACULATIONS FOR WORM

SR.NO. PARAMETER NOTATION


GIVEN PARAMETERS
1 NORMAL PRESSURE ANGLE aN
2 POWER TO BE TRANSMITTED P
3 SPEED OF WORM Nw
4 SPEED OF WORM GEAR Ng
5 VELOCITY RATIO V.R.
6 CENTRE DISTANCE x

A DESIGN OF WORM

LEAD ANGLE l
NORMAL LEAD Ln
AXIAL LEAD La
NO.OF STARTS n
AXIAL PITCH OF WORM Pa
MODULE m

STANDARD MODULE BASED ON CAL. m


AXIAL PITCH OF WORM Pa &Pc
AXIAL LEAD La
NORMAL LEAD Ln
CENTRE DISTANCE X
PITCH CIRCLE DIAMETER Dw
NUMBER OF TEETHS ON GEAR Tg
FACE LENGTH OF WORM Lw
DEPTH OF TOOTH h
ADDENDUM a
OUTSIDE DIAMETER OF WORM Dow
DIAMETER FACTOR q
RM

UNIT

14.5 0 Deg.
513.65 570 Watts
750 0 RPM
25 0 RPM
30 #DIV/0!
31.75 0 mm

5.71 #DIV/0! Deg.


5.0 #DIV/0! mm
5.0 #DIV/0! mm
1 0 FROM TABLE IN COMMENT.VALUE BASED ON VELOCITY RATIO
4.99 #DIV/0! mm
1.59 #DIV/0! mm

1.5875 2 mm
4.98475 6.28 mm
4.98475 0 mm
4.96 #DIV/0! mm
31.75 #DIV/0! mm
15.8767 #DIV/0! mm
30 #DIV/0!
22.5 28.3 mm
3.11 4.31 mm
1.6 1.8 mm
19.05 #DIV/0! mm
10
OCITY RATIO

You might also like