ELECTRIC POWER - Technical Spec Sheet

STANDARD

3516B
1600 ekW/ 2000 kVA/ 50 Hz/ 1500 rpm/ 400 V/ 0.8 Power Factor

Rating Type: CONTINUOUS Fuel Strategy: LOW FUEL CONSUMPTION

3516B
1600 ekW/ 2000 kVA
50 Hz/ 1500 rpm/ 400 V

Image shown may not reflect actual configuration

Metric English

Package Performance
Genset Power Rating with Fan @ 0.8 Power Factor 1600 ekW
Genset Power Rating 2000 kVA
Aftercooler (Separate Circuit) 30.0 ° C 86.0 ° F

Fuel Consumption
100% Load with Fan 396.1 L/hr 104.6 gal/hr
75% Load with Fan 295.7 L/hr 78.1 gal/hr
50% Load with Fan 206.7 L/hr 54.6 gal/hr
25% Load with Fan 122.1 L/hr 32.3 gal/hr

Cooling System¹
Engine Coolant Capacity 233.0 L 61.6 gal
Radiator Water Capacity High Temp Circuit N/A N/A
Radiator Water Capacity Low Temp Circuit N/A N/A
Radiator Total Capacity N/A N/A

Inlet Air
Combustion Air Inlet Flow Rate 139.8 m³/min 4936.5 cfm
Max. Allowable Combustion Air Inlet Temp 43 ° C 109 ° F

Exhaust System
Exhaust Stack Gas Temperature 432.9 ° C 811.2 ° F
Exhaust Gas Flow Rate 346.5 m³/min 12235.4 cfm
Exhaust System Backpressure (Maximum Allowable) 6.7 kPa 27.0 in. water

TSS-DM7970-01-GS-EPG-10589715.pdf © 2020 Caterpillar All Rights Reserved Page 1 of 3

ELECTRIC POWER - Technical Spec Sheet
STANDARD

3516B
1600 ekW/ 2000 kVA/ 50 Hz/ 1500 rpm/ 400 V/ 0.8 Power Factor

Rating Type: CONTINUOUS Fuel Strategy: LOW FUEL CONSUMPTION

Heat Rejection
Heat Rejection to Jacket Water 533 kW 30312 Btu/min
Heat Rejection to Exhaust (Total) 1477 kW 83997 Btu/min
Heat Rejection to Aftercooler 378 kW 21497 Btu/min
Heat Rejection to Atmosphere from Engine 124 kW 7052 Btu/min
Heat Rejection to Atmosphere from Generator 120 kW 6824 Btu/min

Alternator²
Motor Starting Capability @ 30% Voltage Dip 4040 skVA
Current 2887 amps
Frame Size N4343L4
Excitation PM
Temperature Rise 125 ° C

Emissions (Nominal)³
NOx 2935.2 mg/Nm³ 5.9 g/hp-hr
CO 89.2 mg/Nm³ 0.2 g/hp-hr
HC 73.8 mg/Nm³ 0.1 g/hp-hr
PM 12.0 mg/Nm³ 0.0 g/hp-hr

DEFINITIONS AND CONDITIONS

1. For ambient and altitude capabilities consult your Cat dealer. Air flow restriction (system) is added to existing
restriction from factory.

2. UL 2200 Listed packages may have oversized generators with a different temperature rise and motor starting
characteristics. Generator temperature rise is based on a 40° C ambient per NEMA MG1-32.

3. Emissions data measurement procedures are consistent with those described in EPA CFR 40 Part 89, Subpart D & E
and ISO8178-1 for measuring HC, CO, PM, NOx. Data shown is based on steady state operating conditions of 77° F,
28.42 in HG and number 2 diesel fuel with 35° API and LHV of 18,390 btu/lb. The nominal emissions data shown is
subject to instrumentation, measurement, facility and engine to engine variations. Emissions data is based on 100%
load and thus cannot be used to compare to EPA regulations which use values based on a weighted cycle.

Applicable Codes and Standards:

AS1359, CSA C22.2 No100-04, UL142,UL489, UL869, UL2200,
NFPA37, NFPA70, NFPA99, NFPA110, IBC, IEC60034-1, ISO3046, ISO8528,
NEMA MG1-22,NEMA MG1-33, 2006/95/EC, 2006/42/EC, 2004/108/EC.

Note: Codes may not be available in all model configurations. Please consult your local Cat Dealer representative for
availability.

TSS-DM7970-01-GS-EPG-10589715.pdf © 2020 Caterpillar All Rights Reserved Page 2 of 3

ELECTRIC POWER - Technical Spec Sheet
STANDARD

3516B
1600 ekW/ 2000 kVA/ 50 Hz/ 1500 rpm/ 400 V/ 0.8 Power Factor

Rating Type: CONTINUOUS Fuel Strategy: LOW FUEL CONSUMPTION

CONTINUOUS:Output available with non-varying load for an unlimited time. Average power output is 70-100% of the
continuous power rating. Typical peak demand is 100% of continuous rated ekW for 100% of operating hours.

Ratings are based on SAE J1349 standard conditions. These ratings also apply at ISO3046 standard conditions

Fuel Rates are based on fuel oil of 35º API [16º C (60º F)] gravity having an LHV of 42 780 kJ/kg (18,390 Btu/lb) when
used at 29º C (85º F) and weighing 838.9 g/liter (7.001 lbs/U.S. gal.). Additional ratings may be available for specific
customer requirements, contact your Cat representative for details. For information regarding Low Sulfur fuel and
Biodiesel capability, please consult your Cat dealer.

Performance No.: DM7970-01

Feature Code: 516DRE3
The International System of Units (SI) is used in this publication. CAT, CATERPILLAR, their respective
Generator Arrangement: 5026156 logos, ADEM, EUI, S‡O‡S, "Caterpillar Yellow" and the "Power Edge" trade dress, as well as corporate and
product identity used herein, are trademarks of Caterpillar and may not be used without permission.
Date: 03/09/2020
Source Country: CHINA

TSS-DM7970-01-GS-EPG-10589715.pdf © 2020 Caterpillar All Rights Reserved Page 3 of 3