Scribd
Upload
35 views1 page

OM402UNI M 2013 3v3en Part25

This document discusses setting the decimal point projection for temperature measurements using an RTD sensor. It explains that the positioning of the decimal point is set in the measuring mode menu under RTD - Pt. It also shows an example display format of "000000" or "00000.o" depending on where the decimal point is projected. The subsequent menu item then depends on the instrument equipment being used.

Uploaded by

thach pha thien
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
35 views1 page

OM402UNI M 2013 3v3en Part25

This document discusses setting the decimal point projection for temperature measurements using an RTD sensor. It explains that the positioning of the decimal point is set in the measuring mode menu under RTD - Pt. It also shows an example display format of "000000" or "00000.o" depending on where the decimal point is projected. The subsequent menu item then depends on the instrument equipment being used.

Uploaded by

thach pha thien
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

SETTING LIGHT 5.

MEASURING MODE > RTD - Pt



FORM. A 000000 00000. o 0000. o o

FORM. A Setting projection of the


  decimal point
DEF = 00000.o
- positioning of the DP is set here in the measuring
mode

Projection of DP on display > 000000 Example

*subsequent item on the menu depends on


00000. o 000000 MENU instrument equipment

 34

INSTRUCTIONS FOR USE OM 402UNI | 25

You might also like