Scribd
Upload
34 views

FV N R V: Rossby Number

1) The gradient wind equation describes the balance between centrifugal force, horizontal pressure gradient force, and Coriolis force in rotating atmospheric systems. 2) The Rossby number indicates the relative importance of the Coriolis force and centrifugal force. A small Rossby number means geostrophic balance dominates, while a large Rossby number means cyclostrophic balance is valid. 3) Geostrophic balance occurs when isohypses are straight and parallel, causing the Coriolis force to determine wind direction. Cyclostrophic balance neglects the Coriolis force and allows winds to circulate cyclonically or anticyclonically around low pressure areas.

Uploaded by

Serkan Sancak
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
34 views

FV N R V: Rossby Number

1) The gradient wind equation describes the balance between centrifugal force, horizontal pressure gradient force, and Coriolis force in rotating atmospheric systems. 2) The Rossby number indicates the relative importance of the Coriolis force and centrifugal force. A small Rossby number means geostrophic balance dominates, while a large Rossby number means cyclostrophic balance is valid. 3) Geostrophic balance occurs when isohypses are straight and parallel, causing the Coriolis force to determine wind direction. Cyclostrophic balance neglects the Coriolis force and allows winds to circulate cyclonically or anticyclonically around low pressure areas.

Uploaded by

Serkan Sancak
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2



Rossby number
Rotating systems in the atmosphere can be described with the gradient
wind equation. This equation holds the balance between the centrifugal force, the
horizontal pressure gradient force (P) and the Coriolis force (C). As a start we
repeat equation 7.16 from Wallace and Hobbs (page 283):
2 r r
rV
n = - ∇Φ - f k × V (9.1)
RT
which can also be written in component form using natural coordinates:
V2 ∂Φ
=- - fV (9.2)
RT ∂n
To simplify these equations we need to find the relative importance of
individual terms so one can apply “scale analysis”. Relatively small terms can then
be neglected. Note that the pressure gradient force can never be neglected as it is
the only force that can drive horizontal motions in the atmosphere. The other
terms of Equation 9.1 can be neglected under certain conditions.
In case the isohypses are straight and parallel (i.e. no centrifugal force) we
are left with an equation that has been named geostrophic balance. In physical
terms this would mean the radius of curvature is infinitely large ( RT → ± ∞), and
thus the wind follows a straight line. Motions like this are described in Wallace
and Hobbs equation 7.15 (page 281):

Vg =
f
(
1 r
k × ∇Φ ) (9.3)

This equation can be derived from Equation 9.1. It is easier if we put


Equation 9.3 in component form and natural coordinates:
1 ∂Φ
Vg = - (9.4)
f ∂n
To describe the flow around a ‘normal’ (anti)cyclone the full gradient wind
equation is needed. The resulting wind speed is either subgeostrophic (for
cyclones) or supergeostrophic (for anticyclones).
Neglecting the Coriolis force is permitted in cases with small horizontal
scale. The remaining equation is a cyclostrophic balance. In this case the
direction of the flow is not determined by the Coriolis force and can be both
cyclonic and anticyclonic around a low pressure area (Figure 9.1). Using Equation
9.2 this would lead to
V2 ∂Φ
=-
RT ∂n
Equation 8.5 on page 352 of Wallace and Hobbs states the same result but
for isobars instead of isohypses:
v 2 1 ∂p
= (9.5)
r ρ ∂r
r r
Note that Wallace and Hobbs have replaced the n -coordinate with the r -
coordinate which is in the opposite direction, hence the minus sign has
disappeared. Also note that the geopotential has been rearranged to pressure
(using equation 3.20 of Wallace and Hobbs, page 68).
To determine whether it is allowed to neglect the Coriolis force the Rossby
number is often used. The Rossby number is a dimensionless [-] indicator of the
relative importance of the Coriolis force to the centrifugal force. The formal
definition is:
V2
Fcf R V
Ro ≡ = T = (9.6)
C fV f RT
Small values ( Ro ≈ 0 - 0.1 ) of the Rossby number indicate that the flow is
nearly in geostrophic balance. Large values ( Ro > 100 ) of the Rossby number
indicate that cyclostrophic balance is valid.

v
Fcf
L L
P P Fcf
C
v
(a) (b)
Figure 9.1 Force balance around an anti-clockwise turning Low pressure area (a) and a
clockwise turning Low pressure area (b). Both in the Northern Hemisphere. The latter can
only exist if the Coriolis force is small compared to the other forces (e.g. in dust devils).

You might also like