PARKING BRAKE SYSTEM

F BRAKES

B
SECTION
PARKING BRAKE SYSTEM C

E
CONTENTS
NOISE, VIBRATION AND HARSHNESS (NVH) Components ............................................................. 4 PB
TROUBLESHOOTING ................................................ 2 Removal and Installation .......................................... 4
NVH Troubleshooting Chart ..................................... 2 REMOVAL ............................................................. 4
PARKING BRAKE SYSTEM ...................................... 3 INSTALLATION ..................................................... 5 G
On Board Inspection and Service ............................ 3 SERVICE DATA AND SPECIFICATIONS (SDS) ........ 6
LEVER STROKE ................................................... 3 Parking Brake ........................................................... 6
Adjustment ............................................................... 3
H

PB-1
 NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING

NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING PFP:00003

NVH Troubleshooting Chart EFS002FN

Use the chart below to help you find the cause of the symptom. If necessary, repair or replace these parts.

NVH in RSU section

NVH in RAX section

NVH in WT section

NVH in WT section

NVH in PS section
BR-28

BR-27

BR-28

BR-28
—

—
Reference page

Return spring damaged

Linings - uneven wear
Linings - damaged

Drum deformation
Drum imbalance

Drum deflection

ROAD WHEEL
SUSPENSION
Drum damage
Possible cause and

Drum runout

STEERING
SUSPECTED PARTS

Drum rust

TYRES
AXLE
Noise X X X X X X X X
Symptom BRAKE Shake X X X X X X
Shimmy, Judder X X X X X X X X X X X
X: Applicable

PB-2
 PARKING BRAKE SYSTEM

PARKING BRAKE SYSTEM PFP:36010

A
On Board Inspection and Service EFS002FO

LEVER STROKE
● Operate parking brake lever with a force of 196 N (20 kg, 44.1 lb). Check if stroke is within specified num- B
ber of notches. (Check it by hearing clicks of ratchet.)
Lever stroke :11-12 notches
C
Adjustment EFS002FP

1. Insert a socket wrench into opening of parking brake lever.

Rotate adjusting nut to fully loosen cable, then return parking D
brake lever.
2. Depress the foot brake several times (about 2 or 3 times) and
adjust the rear shoe clearance.
E
NOTE:
Be sure to securely depress the foot brake.
PB

SFIA1111E

G
3. Rotate the road wheels to make sure that there is no drag.
4. Use the following procedure to adjust the cable.
a. Pull the lever up to the position where a socket wrench can be H
inserted.
b. Insert a socket wrench into the opening of the lever, and rotate
the adjusting nut to adjust lever stroke. I
NOTE:
Do not reuse adjusting nut after removing it.
J
MAA0182D

c. After operating the lever 3 to 4 times with a force of 196 N (20 kg, 44.1 lb), make sure that the lever stroke K
is within the specified number of notches.
d. With the lever completely returned, make sure that there is no drag on the rear brake.
L

PB-3
 PARKING BRAKE SYSTEM

Components EFS002FQ

SFIA1110E

1. Device assembly 2. Screw 3. Warning lamp switch

4. Adjusting nut 5. Front cable 6. Rear left cable
7. Rear right cable

Removal and Installation EFS002FR

REMOVAL
1. Remove the console box. Refer to IP-9, "REMOVAL AND
INSTALLATION OF CONSOLE BOX." .
2. Disconnect warning lamp switch connector.
3. Loosen adjusting nut and separate the rear left and rear right
cable.
4. Remove device assembly tightening nuts, and remove device
assembly from vehicle.

SFIA0675J

5. Remove tire from vehicle.

6. Remove rear brake shoe and remove cable from the operating lever. Refer to BR-27, "Components" .
7. Remove the exhaust center tube and heat plate. Refer to EX-3, "EXHAUST SYSTEM" .
8. Disconnect the rear cable mount and remove it from the vehicle.

PB-4
 PARKING BRAKE SYSTEM

INSTALLATION
1. Install in the reverse order of removal. Tighten nuts and bolts to the specified torque. A
2. Adjust the parking brake. Refer to PB-3, "Adjustment" .

PB

PB-5
 SERVICE DATA AND SPECIFICATIONS (SDS)

SERVICE DATA AND SPECIFICATIONS (SDS) PFP:00030

Parking Brake EFS002FS

Control type Center lever

Lever stroke [operating force 196 N (20 kg, 44.1 lb)] 11 - 12 notches
Full stroke 15 notches
Brake warning lamp stroke 1 notch or less

PB-6