Scribd
Upload
206 views

RRC Optimization

The document provides recommendations for improving the RRC connection, including adjusting parameters like MAXNUMRRC, ActPucch, and PRACHCS. It also suggests improving CQI by using MIMO techniques and minimizing SINR variations between servers. Points to check for improving uplink include scheduling, buffer status reporting, power headroom reporting, and link adaptation configuration.

Uploaded by

kumar
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
206 views

RRC Optimization

The document provides recommendations for improving the RRC connection, including adjusting parameters like MAXNUMRRC, ActPucch, and PRACHCS. It also suggests improving CQI by using MIMO techniques and minimizing SINR variations between servers. Points to check for improving uplink include scheduling, buffer status reporting, power headroom reporting, and link adaptation configuration.

Uploaded by

kumar
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

For RRC Improvement

FOr RRC-
-MAXNUMRRC
-ActPucch
-PRACHCS-10 to 8
-Pmaxcch

CQI:-
Mimomode
ActfastMimoswitch
MimoclcqithD/U
CQI is fixed as per modulation, so if you want to have batter CQI..improve your SINR.

you will using only 1 carrier, so try to remove overlapping ( reduce the number of server within
3, 5 & 10 Db).
also, if possible then make Your PCI plan as per MOD3,MOD6 & MOD30.

For uplink.

from radio side below are the points to check.


–Uplink scheduling overview
–BSR (Buffer Status Report)
–PHR (Power Headroom Report) – is the UE at maximum power?
–Cell bandwidth vs. maximum allowable PRBs
–Link Adaptation
–MCS available and 16QAM
–PDCCH SIB scheduling colliding with UL grant

Ericsson Vendore spaecific:-

›dlChannelBandwidth / ulChannelBandwidth
›(nrOfSymbolsPdcch) (Control Region Size) ß
›noOfUsedTxAntennas ß controls whether OLSM MIMO is used (2) or not.
›partOfRadioPower ß NOTE: this is the % part of RU capability independent of
SectorEquipmentFunction::confOutputPower settings
›pZeroNominalPucch ß some UEs need this to be increased or ACK/NACKs are not received
successfully on PUCCH.
›pZeroNominalPusch ß some UEs need this to be increased from default or lots of errors seen
on PUSCH
–SectorEquipmentFunction=Sx
›confOutputPower / fqBand (readOnly)
–DataRadioBearer
›Various parameters for RLC status reporting and retransmission. Should be set to
recommended values.
–MACConfiguration
›xxMaxHARQTx – enable (>1) or disable (1) HARQ. Recommended to use 4 HARQTx.
›tPeriodicBSRTimer – seen in UE testing to have some impact, recommend to set to 5ms.
›tTimeAlignmentTimer – seen in UE testing to have some impact, recommend to set to 5120ms

You might also like