SET-1

GURU NANAK INSTITUTE OF CODE

TECHNOLOGY
(NBA Accredited for ECE, CSE & MECH, Approved By AICTE, New Delhi & Affiliated to JNTUH 83
Hyderabad)
Khanapur Village, Ibrahimpatnam, Manchal Mandal, Ranga Reddy Dist, Telangana -501506.

B. Tech I Year I Sem. I Internal Examinations, Feb-2021

SUBJECT: Basic Electrical Engineering
Date: /3/2021 Time: 60 Min
BRANCH: EEE
Max.Marks:20

Answer Any 2 Question s Marks: 2X5M =

10Marks
Blooms
Q.No Question
Level
A) State Kirchhoff’s voltage law and Kirchhoff’s current law? L2
1
B) Explain ideal voltage and current source? L2
A) Define RMS Value? L1
2
B) List any five advantages of alternating quantities? L1

3
A series has R=5Ω , L=0.15mH ,and C=100μF and is supplied with 230V,50Hz single L3
phase. Find impedance, current, power, power factor of the circuit.

4 L2
Explain the working principle of transformer and derive the EMF equation.

***ALL THE BEST***

 SET-2
GURU NANAK INSTITUTE OF CODE
TECHNOLOGY
(NBA Accredited for ECE, CSE & MECH, Approved By AICTE, New Delhi & Affiliated to JNTUH 83
Hyderabad)
Khanapur Village, Ibrahimpatnam, Manchal Mandal, Ranga Reddy Dist, Telangana -501506.

B. Tech I Year I Sem. I Internal Examinations, Feb-2021

SUBJECT: Basic Electrical Engineering
Date: /3/2021 Time: 60 Min
BRANCH: EEE
Max.Marks:20
Answer Any 2 Question s Marks: 2X5M =
10Marks
Blooms
Q.No Question
Level
1 Explain the Transient response in Series RL circuit . L2

Find the current in 10ohm resisitor for the following circuit by using superposition
theorem.

2 L3

3 A series has R=25Ω , L=0.25mH ,and C=500μF and is supplied with 230V,50Hz single L3
phase. Find impedance, current, power factor of the circuit.

4 Explain the working principle of transformer and derive the EMF equation. L2
 SET-1
GURU NANAK INSTITUTE OF CODE
TECHNOLOGY
(NBA Accredited for ECE, CSE & MECH, Approved By AICTE, New Delhi & Affiliated to JNTUH 83
Hyderabad)
Khanapur Village, Ibrahimpatnam, Manchal Mandal, Ranga Reddy Dist, Telangana -501506.

B. Tech I Year I Sem. I Internal Examinations, Feb-2021

SUBJECT: Basic Electrical Engineering
Date: /3/2021 Time: 20 Min
BRANCH: EEE
Max.Marks:10

Name: H.T. NO.

Answer All Question

s Marks: 20X1/2M = 10Marks

1. The minimum requirements for causing flow of current are [ ]

   A. A voltage source, a resistor and a switch
   B. A voltages source and a conductor
   C. A power source and a bulb
   D. A voltage source, a conductor an ammeter and a switch

2. Which is the best conductor of electricity [ ]

   A. Iron    B. Silver  C. Copper    D. Carbon

3. The resistance of a conductor varies inversely as [ ]

   A. Length    B. Area of cross-section
   C. Temperature    D. Resistivity

4. Which of the following quantities remain the same in all parts of a series
Circuit [ ]
   A. Voltage    B. Current    C. Power    D. Resistance

5. Core type transformer is used for [ ]

a) Low voltage ,high current
b) Low voltage high current
c) high voltage ,low current
d) high voltage high current.

6A transformer will work on………. [ ]

a) ac b) dc c) ac as well as dc d)only on 3-phase supply.
7.Purely inductive circuit takes power from the ac mains when [ ]
a) both applied voltage and current increase.
b) both applied voltage and current decrease.
c) applied voltage decreases but current increases.
d) applied voltage increases but current decreases.

8.The power factor of a practical inductor is [ ]

a) unity. B) zero. c) lagging. d) leading.

9.The power factor of an ac circuit is equal to [ ]

a) cosine of the phase angle.
b) sine of the phase angle.
c) unity for a resistive circuit.
d)unity for a reactive circuit.

10.The power factor of the following circuit will be zero [ ]

a) resistive.
b) inductive.
c) capacitive.
d)series R,L,C.
Fill in the Blanks

11. The Thevenin voltage is the__________ .

12. Norton resistance is found by _______________.
13. In superposition theorem, when we consider the effect of one voltage source, all the other current
sources are ____________.
14. Mesh analysis employs the method of ___________ .
15.Transformer core is laminated to ___________.
16.Transformer core is lamination made with ________________.
17.The time period of a 1000kHz voltage is __________milli seconds.
18.. What is the condition for resonance ___________.
19.For resonant series circuit ,for f < fr ,the behaviour of circuit is ___________.
20.The power factor of an ac circuit lies between _________.
 ***ALL THE BEST***

SET-2
GURU NANAK INSTITUTE OF CODE
TECHNOLOGY
(NBA Accredited for ECE, CSE & MECH, Approved By AICTE, New Delhi & Affiliated to JNTUH 83
Hyderabad)
Khanapur Village, Ibrahimpatnam, Manchal Mandal, Ranga Reddy Dist, Telangana -501506.

B. Tech I Year I Sem. I Internal Examinations, Feb-2021

SUBJECT: Basic Electrical Engineering
Date: /3/2021 Time: 20 Min
BRANCH: EEE
Max.Marks:10

Name: H.T. NO.

Answer All Question
s Marks: 20X1/25M = 10Marks

1. When two resistors are connected in series total resistance is 8Ω and when connected in parallel,
equivalent resistance is 2Ω. Values of resistances are [ ]
A. 5Ω and 3Ω B. 6Ω and 2Ω
C. 4Ω and 4Ω D. 7Ω and 1Ω
2. The sum of the voltages over any closed loop is equal to ________ [ ]
A. 0V B. Infinity C. 1V D. 2V
3. In a parallel circuit, with a number of resistors, the voltage across each resistor is ________
[ ]
A. The same for all resistors
B. Is divided equally among all resistors
C. Is divided proportionally across all resistors
D. Is zero for all resistors
4. Calculate the current through the 20 ohm resistor [ ]

A. 20A B. 1A C. 0.67A D. 0.33A

5. The current in each branch of a parallel circuit is proportional to ___ [ ]
A. The amount of time the circuit is on for
B. Proportional to the value of the resistors
C. Equal in all branches
D. Proportional to the power in the circuit
6.When a series R-L-C circuit is under resonance [ ]
a) current is maximum b) current is minimum
c) impedance is maximum d) power factor is lagging

7.At resonance frequency an RLC circuit draws maximum current due to the reason that [ ]
a) the difference between capacitive reactance and inductive reactance is zero.
b) the impedance is more than resistance.
c) the voltage across the capacitor is equal to applied voltage.
d) the power factor is less than unity.
8.For a series RLC circuit,the power factor at the lower power frequency is [ ]
a)0.5 lagging. B) 0.5 leading. C) unity. D) 0.707 leading.
9.The bandwidth of a resonant circuit is given by [ ]
a)R/2πL B) f_r/2 c) 2πL/R D) zero.
10.In a RLC series circuit VR=3V, VL= 8V and VC= 4V , the applied voltage is [ ]
a)15v b)5v c)8v d)7v

Fill in the Blanks

11.For resonant series circuit ,for f > fr ,the behaviour of circuit is___________.
12.In a balanced 3-phase star connected system lags behind by __________electrical degrees.
13.The power factor of an ac circuit is equal to _________.
14.The time period of a complete sine wave is ______.
15.In a series resonant circuit ,the impedance of the circuit is___________.
16. Energy stored in inductor is____________.
17. At steady state, the inductor will behave as____________ .
18. At steady state, the capacitor will behave as____________ .
19.Core type transformer is used for __________.
20. An ideal transformer is one which ____________.