0% found this document useful (0 votes)
144 views2 pages

Manual ND4

Uploaded by

mariopilar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
0% found this document useful (0 votes)
144 views2 pages

Manual ND4

Uploaded by

mariopilar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 2
‘Temperature Controller ND4 INSTRUCTION MANUAL “This manual rnary deserbos precautions requied in tnsaling and wing te temperature controle. When using the imperature conti, please eer oe parinent ‘eaogfordelaled oration. reo ore Inova FACTORY ani04xe120813, HaTYOUNG NUX HANYOUNGNUK CO.,LTD 1981-3 se-Dong, Nen-Gu ree, Koes TEL aaeTeae POL aaa PL MAVOUNG BECTON MOOREA “Roar 78a Data Son 1 ‘amg mn aera PK: -O- PB-Output capacity 0% Tinh ee PT=PB—Output capacity 50% a PT: Present (Process) Temperature PB: Proportional Band SV: Setting Value (Temperature) PC: Proportional Cycle @ position Control, ON-OFF Control This isa control method that PT is higher than SV then output will be OFF orif PT is less than SV, then the output will be ON. Als, itis called 2-positon control since it outputs either 0% or 100%. The status which the temperature is unstable and there Is highfiow wave around ‘SVs called hunting. The width between the point where ts output i (OFF because PT is higher than SV and the point where its outputs ON since PTs ees than SVs called acjusting sensitivity, hysteresis. It ‘the width, hysteresis, is nartow, then highiow wave becomes smaller but the cycle of ON-OFF gets smaller so thatt may severely damage tbelecromagnete such, eae, tioctovale ore oe eae ee burner which is using vane feum oraucrorae 2 TTT oun naa grey ce oom i lf 27 Pert Pn) Teneo Suan fenstae @ Proportional Control/ ON-OFF Control Selection Itis depending on its specification code when you are ordering. ‘@ Panel Cutout Dimension t—— —— L | LU at |

You might also like