Scribd
Upload
179 views1 page

Dump Pump Relief Valve - Rp-5514

This document provides information about relief valves for dump pumps used in hydraulic and pneumatic systems. It describes potential issues if dirt or damaged parts allow oil to bypass the relief valve. It also provides instructions for recalibrating the relief valve from its standard 2000 PSI factory setting to 2500 PSI by adjusting specific numbered parts.

Uploaded by

UB Heavyparts
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
179 views1 page

Dump Pump Relief Valve - Rp-5514

This document provides information about relief valves for dump pumps used in hydraulic and pneumatic systems. It describes potential issues if dirt or damaged parts allow oil to bypass the relief valve. It also provides instructions for recalibrating the relief valve from its standard 2000 PSI factory setting to 2500 PSI by adjusting specific numbered parts.

Uploaded by

UB Heavyparts
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

R

HYDRAULIC / PNEUMATIC PRODUCTS


1500 Frost Road • Post Office Box 2068 • Streetsboro, Ohio 44241-0869 • 330/626-2801 • Fax: 330/626-2805

To: All Permco Distributors Date: July 12, 1994

Subject: DUMP PUMP RELIEF VALVE

Series: DM-512-20, DM-640-25, DMD-20 and DMD-25

DUMP PUMP RELIEF VALVE -RP-5514

5 3 6 12 6 4
If items 9 or 10 are
1 2 11 8 7 9 10
damaged, oil will
bypass relief valve

ITEM PART NO. DESCRIPTION REQ'D


1 RP-5514-1 CARTRIDGE 1
2 RP-5514-2 SPRING 1
If dirt or debris gets under ball between 3 RP-5514-3 SPRING RETAINER 1
4 RP-5514-4 BALL RETAINER 1
ball and seat oil will bypass relief 5 RP-5514-5 ACORN NUT 1
and/or allow cylinder to drift down 6
7
RP-5514-6
RP-5514-7
COMPRESSION 1
WASHER 1
8 RP-5514-8 BALL 1
9 RP-5514-9 QUAD RING 1
10 RP-5514-10 BACK-UP RING 1
11 RP-5514-11 "O"-RING 1
12 RP-5514-12 "O"-RING 1

* In the event the relief valve To set relief valve to 2500 PSI, when
is disassembled - Calibration it is set at 2000 PSI from the factory
must be done on a test stand remove item #5, loosen item #12, turn item #3
3/8 of a turn clockwise then tighten item #12
and replace item #5.

NATIONAL FLUID POWER ASSOCIATION Page 22 of 158 5/13/2010

You might also like