Scribd
Upload
47 views

Quiz 1

This document contains a 7 question quiz on hydraulics fundamentals, Bernoulli's energy theorem, and fluid flow measurement tools. It provides guidelines for answering the questions, including writing responses in 3 decimal places and submitting answers within 3 hours. The questions cover topics like fluid velocity and pressure changes, flow rates measured by a venturi meter and Pitot tube, power calculations involving pipe flows, and estimating output from a hydraulic turbine.

Uploaded by

KATHRYNE BERNARDO
Copyright
© © All Rights Reserved
47 views

Quiz 1

This document contains a 7 question quiz on hydraulics fundamentals, Bernoulli's energy theorem, and fluid flow measurement tools. It provides guidelines for answering the questions, including writing responses in 3 decimal places and submitting answers within 3 hours. The questions cover topics like fluid velocity and pressure changes, flow rates measured by a venturi meter and Pitot tube, power calculations involving pipe flows, and estimating output from a hydraulic turbine.

Uploaded by

KATHRYNE BERNARDO
Copyright
© © All Rights Reserved
You are on page 1/ 5

Quiz 1 - Hydraulics (HDRA 3B)

Topics: Fundamentals of Fluid Flow, Bernoulli's Energy Theorem, Fluid Flow Measurement -
Pitot tube and Venturi meter Guidelines: 1. Read, solve, and answer the following questions.
2. If you found a given which has blank, write the last two digits of your student number. (Ex.
My student number is 19-0587 and the given is 2 _ _.00 kN, it will become 287.00 kN. 3. All
values should not be rounded off until the final answer. 4. Write your answer in THREE (3)
decimal places. 5. You will be given 3 hours to answer the questions (no extension). 6. Do
not forget to SUBMIT your quiz for it to be recorded.
Points:
-/50
11,
What is your student number?Required to answer. Multi Line Text.

22,
A jet of seawater 5_._ mm in diameter is directed vertically upwards with an initial
(datum) velocity of _ . _ m/s. The seawater relative density is 1.03. a. Determine
the jet velocity (m/s) 2. _ _ m above datum. b. Determine the jet diameter (m) 2._ _
m above datum. c. At what height (m) above datum would the jet come to rest?
Required to answer. Multi Line Text.
(-/15 Points)

33,
A horizontal venturi meter (C = 0.97) was used to measure the flow of oil having
a sp. gr. of 0.8_ _ and the recorded flow rate is 8. _ _ L/sec. The diameter of the
pipe is 37. _ _ mm while that of the throat is 25. _ _ mm. The liquid in the
differential gage shown contains mercury having a sp. gr. of 13.6 and the rest is
filled with oil. The head lost from the inlet to the throat is _ . _ 0% of the velocity
head in the throat and from the throat to outlet is 2 _ . _ % of the velocity head in
the throat. a. Calculate the value of h_1 in mm. b. Determine the value of h_2 in
mm.Required to answer. Multi Line Text.
(-/10 Points)
44,
Determine the power (kW) the pump must deliver to produce the flow as shown.
Here the elevations at points P, Q, R, and S are 4_ . _ m, 6_ . _ m, 35. _ _ m, and 30.
_ _ m, respectively. The nozzle area is 2_ . _ cm^2.Required to answer. Multi Line
Text.

(-/5 Points)
55,
A Pitot tube was used to measure the discharge of water flowing in a 300 mm
diameter pipe. The stagnation pressure at the center line of the pipe is 250 mm
of water more than the static pressure. If the mean velocity is 0.7_ _ of the center
line velocity and the coefficient of the Pitot tube is 0.9_ _. Find the flow rate of
flow in L/s.Required to answer. Multi Line Text.
(-/5 Points)
66,
A duct of diameter 80_ . _ mm carries water. At one point, the duct diameter
reduces by 60 mm. The pressure difference between a point upstream of the
reduction and another point at the reduction is equivalent to 3_ . _ mm of water.
a. Estimate the velocity of flow (m/s) in the reduced section. b. Determine the
mass flow rate (kg/s).Required to answer. Multi Line Text.
(-/10 Points)

77,
Assuming that the turbine shown in the figure has an efficiency of 9 _ . _% and
that the overall head loss is 1._ _ of the velocity head in the 7 ft penstock. What
output horsepower may be expected from the turbine if the flow rate is 5 _ _
ft^3/s?Required to answer. Multi Line Text.
(-/5 Points)
Go back to thank you page
This content is created by the owner of the form. The data you submit will be sent to the form owner. Microsoft is not
responsible for the privacy or security practices of its customers, including those of this form owner. Never give out
your password.

Powered by Microsoft Forms


 | 
Privacy and cookies
 | Terms of use

You might also like