Scribd
Upload
99 views1 page

Practical Exercise 5

The document provides instructions for an assignment to create a project drawing of a hole puncher using ANSI standards. Students must produce an assembly drawing, exploded drawing with bill of materials, and detailed part drawings. Drawings must be arranged systematically and include all required information in the provided title block. Drawings must be printed at the proper scale and saved as a PDF. The assignment will be evaluated based on clarity of assembly, use of exploded views, dimensioning and tolerancing of parts, adherence to ANSI standards, systematic arrangement, and completeness of the title block.

Uploaded by

Ahmad Faidhi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
99 views1 page

Practical Exercise 5

The document provides instructions for an assignment to create a project drawing of a hole puncher using ANSI standards. Students must produce an assembly drawing, exploded drawing with bill of materials, and detailed part drawings. Drawings must be arranged systematically and include all required information in the provided title block. Drawings must be printed at the proper scale and saved as a PDF. The assignment will be evaluated based on clarity of assembly, use of exploded views, dimensioning and tolerancing of parts, adherence to ANSI standards, systematic arrangement, and completeness of the title block.

Uploaded by

Ahmad Faidhi
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

FACULTY OF MECHANICAL AND MANUFACTURING ENGINEERING

UNIVERSITI TUN HUSSEIN ONN MALAYSIA


BDA 30903, SOLID MODELLING
Assignment 5

Project drawing

Create a Project drawings of “HOLE PUNCHER” using ANSI standard. The drawing must include

i. Assembly drawing
ii. Exploded drawing with BOM
iii. Detailed parts drawing

Assume Pin, Base Pin & Spring are the standard part for this assembly.

You are require to arrange this project drawing in systematic approach and fill all the information
required in the provided title block.

The drawing must be print out in proper / correct scale and save it in PDF.

Marking criteria.

Evaluate item Marks

i. Show assemble component in 3D drawing with adequate clarity 0.75


ii. Use exploded views with BOM to show assemble of parts 0.75
iii. Provide adequate dimensioning and tolerance to build part properly 1.00
iv. Adheres to ANSI standard 1.00
v. Arrange the drawing in systematic approach 0.75
vi. Fill all the information required in the drawing title block 0.75
Total 5.00

C. K. Sia 2017 Assig 5 BDA 30903


SEM1201819

You might also like