Scribd
Upload
80 views

SNMP Web Box Quick Guide

The document provides instructions for configuring an SNMP web box for monitoring an off-grid inverter. It includes the following key steps: 1. Install SNMP web manager software on a PC which will create a desktop icon. 2. Enter the SNMP box's IP address in the software to search for and detect it over the local area network. 3. Access the SNMP web manager interface to modify settings like the IP address, complete online upgrades, manage passwords using the default password of "12345678", and set static trap addresses.

Uploaded by

Ly Quoc Vu
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
80 views

SNMP Web Box Quick Guide

The document provides instructions for configuring an SNMP web box for monitoring an off-grid inverter. It includes the following key steps: 1. Install SNMP web manager software on a PC which will create a desktop icon. 2. Enter the SNMP box's IP address in the software to search for and detect it over the local area network. 3. Access the SNMP web manager interface to modify settings like the IP address, complete online upgrades, manage passwords using the default password of "12345678", and set static trap addresses.

Uploaded by

Ly Quoc Vu
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

3.

Configuration
SNMP Web Box Quick Guide V. 1.1
a) Please install SNMP web manager software in your PC. After software is
For Off-grid Inverter
installed successfully, the Installer will leave a shortcut icon on
1． Overlook your desktop.

Ethernet port(10/100Base-T)
RS-232 port
5Vdc DC input Chart 3-1
Data receiving indicator b) Enter specific IP address to search all SNMP devices in LAN. (The SNMP
Data transmission indicator web manager will automatically collect the IP address from sever by
Power indicator default via a DHCP server. It will apply default IP address of
192.168.102.230, default subnet mask as 255.255.255.0, and default
Chart 1-1 gateway as 0.0.0.0 without a DHCP server.
Ethernet port status LEDs:
100M LED (Green) Flash Port is operating at 100Mbit/s
Off Card is not connected to the network
10M LED (Yellow) Flash Port is operating at 10Mbit/s
Off Card is not connected to the network

2. Connection
Use one Ethernet cable to connect to Ethernet port () of the box. Use one RJ45
cable to connect to RS-232 port () of the box and RS-232 port of the inverter.
Then, use bundled USB cable to connect to USB port () of the box and 5V DC
USB power source.

Chart 3-2

c) User can modify IP setting, online upgrade, password management, and


Chart 2-1
static trap address setting in SNMP Web Manager interface. It is necessary
to enter password for any modifications. The default password is
12345678.
4. Monitoring
Double click the selected device from the device list (refer to Chart 3-2) to open
web page as Chart 4-1.

Chart 4-1

For detailed configuration, please check SNMP Web Management User Manual for
off-grid inverter.

You might also like