6211

2/2-way Solenoid Valve with

servo-diaphragm, G 3/8 - G 1

• High flow rate

• Cost effective
• Low power consumption
• Compact
• Pressure range 0.5 up to 10 bar
Type 6211 can be combined with...

Type 2506 Type 2507 Type 2510

Cable plug to Cable plug ASI-cable plug
DIN EN 175301-803*) industrial standard
Form C Form B

The Type 6211 is a servo-assisted normally Technical data

closed 2/2-way solenoid valve with a servo- Body material Brass (DIN 50930-6)
diaphragm for use especially with neutral fluids
Body cover PPE/PA
and gaseous media. The valve has a low power
Sealing material NBR, EPDM, FKM
consumption, low weight and a compact body.
Media
NBR neutral gases and fluids (e.g. compressed air, water,
The valve is normally closed by spring force. hydraulic oil, oil, fat without additives);
Energized, the solenoid opens the pilot valve EPDM oil and fat-free media
first. Then the medium pressure opens the (e.g. alkaline washing and bleaching lyes);
main valve due to the pressure drop above the FKM per-solutions, oils with additives
diaphragm. The valve opens. Medium temperature
NBR 0 ... +70 °C
The special design and geometry of the inner EPDM -10 ... +70 °C
parts of the valve result in a soft closing FKM 0 ... +70 °C
function and cause almost no water hammer. Ambient temperature max. +55 °C
Port connection G 3/8 ... G 1 (NPT or RC on request)
Operating voltage 24 V DC
24 / 110 / 230 V / 50-60 Hz
Circuit function A Power consumption 4W
Inrush 9 VA AC, 4 W DC (hot) 5W (cold)
A Hold 6 VA AC, 4 W DC
2/2-way valve,
Voltage tolerance ±10%
servo-assisted,
Duty cycle 100% continuous rating
normally closed
P Electrical connection • Tag connector sidewards
• acc. to DIN EN 175301-803*) Form C for cable plug
(on request)
• acc. to DIN 43650 Form B (industrial standard) for cable
plug Type 2507 (see Ordering chart for accessories)
Installation as required, preferably with actuator upright
Weight see table Response times
Protection class IP 65 with cable plug
Insulating class of coil
Polyamide coil Cable plug Form C - class B
Epoxy coil Cable plug Form B - class H
Flying leads

www.burkert.com p. 1/4
 6211

Response times

1)
Pressure data [bar]: Overpressure with respect to
Orifice Kv value Port Pressure Response times Weight atmospheric pressure
water connection range 2) Closing 2)
For opening the full cross-section, a pressure
Opening Closing difference of 0.5 bar is required.
1)
[kg] [m³/h] [mm] [bar] [ms] [ms] [kg]
10 1.9 G3/8, G1/2 0.5-10 20-25 100-120 0.31
13 3.6 G1/2, G3/4 0.5-10 100-200 200-250 0.44
20 8.3 G3/4, G1 0.5-10 400 500-700 1.03

• Kv value [m³/h]: Flow rate value for water, measured at +20 °C and 1 bar1) pressure differential
over a fully opened valve.
• Response times [ms]: measured at valve outlet at 6 bar1) and +20 °C
Opening: pressure build-up 0 ... 90%, Closing: pressure relief 100 ... 10%

Materials

1 Body Brass
2 O-ring NBR, FKM, EPDM
 
3 Diaphragm support PPS
  4 Spring St. st. 1.4310
5 Body cover PPE/PA
  6 Plunger St. st. 1.4105
7 Spring St. st. 1.4310
 
8 Coil
 
DIN EN 175301-803*) C PA (on request)
DIN 43650
  (industrial standard) Form B Epoxy
9 Diaphragm holder Brass, PPS
  10 Bolt Brass
11 Diaphragm NBR, FKM, EPDM
 
12 Flange Steel
  (thick-film passivated acc. to Rohs)
13 Shading ring Cu
14 Locknut Steel
(thick-film passivated acc. to Rohs)

p. 2/4
 6211

Ordering chart for valves (other versions on request)

Type 6211 Solenoid Valve with coil Form B (industrial standard) for cable plug, Type 2507
(cable plug not supplied)

Item no. per voltage/frequency [V/Hz]

Port connection
Circuit function

Pressure range

110/50-60

230/50-60
24/50-60
Kv value
Orifice

24/DC
[m³/h]

[bar]1)
water
[mm]
DN

A Seal material NBR

A
10 G 3/8 1.9 0.5-10 163 358 163 359 163 360 163 361
G 1/2 1.9 0.5-10 161 944 163 362 163 363 163 364
P 13 G 1/2 3.6 0.5-10 163 384 163 385 163 386 163 387
G 3/4 3.6 0.5-10 163 388 163 389 163 390 163 391
20 G 3/4 8.3 0.5-10 163 408 163 409 163 410 163 411
G1 8.3 0.5-10 163 412 163 413 163 414 161 469
Seal material FKM
10 G 3/8 1.9 0.5-10 163 369 163 370 163 371 163 372
G 1/2 1.9 0.5-10 161 946 163 373 163 374 163 375
13 G 1/2 3.6 0.5-10 163 392 163 393 163 394 163 395
G 3/4 3.6 0.5-10 163 396 163 397 163 398 163 399
20 G 3/4 8.3 0.5-10 163 415 163 416 163 417 163 418
G1 8.3 0.5-10 163 419 163 420 163 421 163 422
Seal material EPDM
10 G 3/8 1.9 0.5-10 163 336 163 337 163 338 163 339
G 1/2 1.9 0.5-10 163 340 163 351 163 352 163 353
13 G 1/2 3.6 0.5-10 163 376 163 377 163 378 163 379
G 3/4 3.6 0.5-10 163 380 163 381 163 382 163 383
20 G 3/4 8.3 0.5-10 163 400 163 401 163 402 163 403
G1 8.3 0.5-10 163 404 163 405 163 406 163 407
1)
Pressure rate [bar]: Overpressure with respect to atmospheric pressure

Ordering chart for accessories

Cable plug Type 2507, Form B Industrial standard
Description

Item no.
Voltage

None (standard) 0 - 250 V AC/DC 423 845

With LED and varistor 24 V AC/DC 423 849
With LED and free-wheeling diode 24 V/DC 423 851
With rectifier, LED and varistor 12 - 24 V AC/DC 423 853
Supplied with cable plug: flat seal and fixing screw.
Other versions of cable plug Form B (industrial standard) with circuitry see separate Datasheet Type 2507.

I &URTHERôVERSIONSôONôREQUEST
Electrical Connection
Coil with cable plug acc. to DIN EN 175301 Form C
Coil with flying leads
Port Connection
Threaded port NPT, Rc
Approvals
UR/CSA

p. 3/4
 6211

Dimensions [mm]

35.5
33.5
3

12
29.7 16.3
22
A

51
B

49.5
P P

F F
E
L
10.5

G
SW
30.3

Coil acc. to DIN EN 175301-803*) Coil acc. to DIN 43650 Form B

14

Form C for cable plug 2506 (industrial standard) for cable plug
Type 2507
20
D

1)
For port connection G thread F1 and G1 applies;
port connection NPT thread F2 and G2;
port connection Rc thread F3 and G3. *)
so far DIN 43650

1) 1) 1) 1) 1) 1)
DN [mm] A B C D E F1 G1 F2 G2 F3 G3 L SW

10 67.5 81.5 32 32 25 14 G1/2 13.7 NPT1/2 13.2 Rc1/2 55 27

10 67.5 81.5 32 32 25 12 G3/8 10.3 NPT3/8 10.1 Rc3/8 55 27
13 72 88 40 46 31 16 G3/4 14 NPT3/4 14.5 Rc3/4 65 32
13 72 88 40 46 31 14 G1/2 13.7 NPT1/2 13.2 Rc1/2 65 32
20 81 101.5 60 60 50 18 G1 16.8 NPT1 16.8 Rc1 100 41
20 81 101.5 60 60 50 16 G3/4 14 NPT3/4 14.5 Rc3/4 100 41

To find your nearest Bürkert facility, click on the orange box www.burkert.com

In case of special application conditions, We reserve the right to make technical changes without notice.
please consult for advice. © Christian Bürkert GmbH & Co. KG 1310/3_EU-en_00891748

p. 4/4