Standard Operating Procedure Initial Config
Standard Operating Procedure Initial Config
Standard Operating
Procedure
Signature:
c. open a new browser and create a test lock in device > administrators > add
b. follow the steps from B (a.) and set an update schedule for applications and threats
with the same criteria
c. follow the steps from B (a.) and set an update schedule for wildfire, the input criteria
for this will be a little different. Set choice to every min and action to download and
install
b. go to network > interface mgmt. > add and create a new profile named ping and
response pages and set the network services to ping and response pages you will need
to repeat the following steps once more and name the next profile ping only and only
select the ping service
c. proceed to network > interfaces > ethernet 1/2 and set the name for the zone to
inside on layer 3, then go to the IPv4 tab make sure the type is set to static and add an
IP address (192.168.1.1/24) then go the advanced tab and set the management profile
to ping and response pages
e. go to network virtual wire and add a wire called danger and set interface1 and
interface2 to ethernet 1/4 and ethernet 1/5
Notes:
Screenshots