Scribd
Upload
63 views

Assingment 2

The document contains 8 questions regarding geotechnical engineering concepts including: 1) Grain size distribution curves, soil classification, and coefficients for 3 soils 2) Soil classification based on plasticity characteristics 3) Liquid limit, plastic limit, plasticity index, and void ratio determination 4) Soil classification based on plasticity characteristics 5) Definition of shrinkage ratio 6) Determination of shrinkage limit, ratio, and volumetric shrinkage from mass and volume data 7) Calculation of shrinkage limit and ratio from liquid and plastic limit data 8) Embankment design calculations including soil, water, and trucking requirements

Uploaded by

Aditya
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
63 views

Assingment 2

The document contains 8 questions regarding geotechnical engineering concepts including: 1) Grain size distribution curves, soil classification, and coefficients for 3 soils 2) Soil classification based on plasticity characteristics 3) Liquid limit, plastic limit, plasticity index, and void ratio determination 4) Soil classification based on plasticity characteristics 5) Definition of shrinkage ratio 6) Determination of shrinkage limit, ratio, and volumetric shrinkage from mass and volume data 7) Calculation of shrinkage limit and ratio from liquid and plastic limit data 8) Embankment design calculations including soil, water, and trucking requirements

Uploaded by

Aditya
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

National Institute of Technology Raipur

Department of Civil Engineering


Assignment - 2
Subject: Geotechnical Engineering I Semester: 5th
Subject Code: CE-513 Due date: 6 – 08 - 16
_____________________________________________________________________________
Q1.Data from grain size analysis for three soils A,B and C is as tabulated below: i) Plot the grain size
distribution curve for each soil; (ii) Classify each soil; (iii) Calculate Cc and Cu for each soil; (iv)
Comment on the validity of Cc and Cu as parameters that describe the shape of the grain size distribution
curve.

Diameter Percentage finer


(mm) A B C
2 100 100 100
1.4 94 100 82
0.6 68 100 53
0.425 54 100 45
0.25 30 100 34
0.212 - - 31
0.18 - 97 30
0.15 16 90 30
0.125 - 76 30
0.09 - 17 -
0.075 4 7 30
0.05 - - 30
0.01 - - 15
0.005 - - 10
0.002 - - 5
Q2. Classify soils A to E as completely as possible on the basis of information given below.

% Clay % Silt % Sand


Soil WL P.I size size size
A 500 450 80 20 0
B 32 7 10 80 10
C 40 20 70 30 0
D - 0 60 40 0
E - 0 0 10 90
Q3. A liquid limit test, conducted on a soil sample in the cup device, gave the following results:

Number of blows 10 19 23 27 40
Water content (%) 60 45.2 39.8 36.5 25.2
Two determinations for the plastic limit gave water contents of 20.3% and 20.8%. Determine (a)
the liquid limit and plastic limit, (b) the plasticity index, (c) the liquidity index if the natural water
content is 27.4%, and (d) the void ratio at the liquid limit if Gs 5 2.7. If the soil were to be loaded
to failure, would you expect a brittle failure?

Q4. A sample of soil weight 1.5 N. Its clay fraction is 0.34N. If its liquid limit is 60% and plastic
limit is 26%. Classify the clay
𝛾𝑑
Q5. Prove that shrinkage ratio (SR) =
𝛾𝑤

Q6. The mass and volume of a saturated clay specimen were 29.8 g and 17.7 cm3 respectively. On oven
drying the mass got reduced to 19 g and the volume to 8.9 cm3. Calculate shrinkage limit, shrinkage ratio
and volumetric shrinkage. Also compute G of soil.

Q7. The liquid limit and plastic limit of a soil are 34% and 26% respectively. When the soil is dried from
its state at liquid limit to dry state the reduction in volume was found to be 35% of its volume at liquid
limit. The corresponding volume reduction from the state of plastic limit to dry state was 25% of its
volume at plastic limit. Calculate (i) shrinkage limit and (ii) shrinkage ratio.

Q8. An embankment for a highway 30 m wide and 1.5 m in compacted thickness is to be constructed
from a sandy soil trucked from a borrow pit. The water content of the sandy soil in the borrow pit is 15%
and its void ratio is 0.69. The swell index is 1.2. The specification requires the embankment to be
compacted to a dry unit weight of 18 kN/m3. Determine, for a 1-km length of embankment, the
following:
(a) The weight of sandy soil from the borrow pit required to construct the embankment.
(b) The number of truckloads of sandy soil required for the construction. The full capacity of each truck
is 22.2 m3, and local government regulations require a maximum loaded capacity of 90%.
(c) The weight of water per truckload of sandy soil.
(d) The degree of saturation of the sandy soil in situ.

You might also like