Product Datasheet: ARC 10

A machinable polymer alloy blend used to resurface scored and

pitted regions which may be machined at a later stage to tight
tolerances. ARC 10 industrial coating is designed to:
■■ Resurface worn metal parts which require machining to tolerances afterwards
■■ Resurface corroded and pitted metal surfaces
■■ Easily apply by trowel

Application Areas Features and Benefits

■■ Flange faces ■■ Worn valve bodies ■■ Shafts ■■ Resistant to wide spectrum of
■■ Scored hydraulic rams ■■ Bearing housings ■■ Pitted metal chemicals including Alkalis, Acids
■■ Worn keyways ■■ Corroded stuffing boxes ■■ Bearing housings & Solvents
■■
Covers a broad range of chemical
exposures. Get it right the first
time
■■ 100% solids; no VOCs; no free
Packaging and Coverage isocyanates
Nominal, based on a 3 mm (120 mils) thickness ■■
Enhances safe use
■■ 250 g kit covers 520 cm (76 in )
2 2
■■ High build viscosity
■■ 1 kg kit covers 2110 cm2 (2.1 ft2) ■■
Suitable for rebuilding pitted and
Note: Components are pre-measured & pre-weighed. scored surfaces to a thickness of
>6 mm (.25”) in a single coat
Each kit includes mixing and application instructions plus
tools. ■■ Polymer alloy reinforced
Color: Gray ■■
Ease of machining

Technical Data
Composition Matrix A modified epoxy resin reacted with an aliphatic amine curing agent
Reinforcement Proprietary blend of metallic alloy particles
Cured Density 2.0 g/cc 125 lb/ cu.ft.
Tensile Adhesion (ASTM D 4541) 256.6 kg/cm2 (25.2 MPa) 3,650 psi
Compressive Strength (ASTM D 695) 930 kg/cm2 13,000 psi
Flexural Strength (ASTM D 790) 710 kg/cm2 10,000 psi
Flexural Modulus (ASTM D 790) 3.6 x 104 kg/cm2 5.1 x 105 psi
Tensile Strength (ASTM C 638) 280 kg/cm2 4,000 psi
Taber Wear Weight Loss (ASTM D 4060) (H-18/250 g/1000 cycles) 275 mg
Composite Shore D Durometer Hardness (ASTM D 2240) 86
Vertical Sag Resistance
No sag
at 21°C (70°F) and 6 mm (1/4")
Maximum Temperature Wet Service 66°C 150°F
(Dependent on service) Dry Service 93°C 200°F

A.W. Chesterton Company

860 Salem Street, Groveland, MA 01834 USA
978-469-6888 www.ARC-EPC.com Technical Data reflects results of laboratory tests and is intended to indicate general characteristics only. Since many actual application circumstances are
[email protected] beyond Chesterton's knowledge and/or control, the product user must determine the suitability of the products it intends to use for its particular purpose and
©  2014 A.W. Chesterton Company assume all risks and liabilities in connection therewith. CHESTERTON DISCLAIMS ALL WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING WARRANTIES OF

®  Registered trademark owned and licensed

by A.W. Chesterton Company in USA and
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.

other countries, unless otherwise noted. Form No. 084972 ARC 10 2014/10/20