Scribd
Upload
482 views

DTC P1782 T/F L4 Range Position Switch Performance: Circuit Description

This document provides diagnostics information for a P1782 trouble code related to the transfer L4 position switch for an automatic transmission. It indicates that the switch is remaining on. The circuit description notes that the ECM detects the signal from the switch. Inspection procedures include checking for voltage at the switch connector terminal and between the terminal and the ECM to diagnose a short, faulty switch, control ECU or ECM as potential trouble areas.

Uploaded by

limadacarlos
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
482 views

DTC P1782 T/F L4 Range Position Switch Performance: Circuit Description

This document provides diagnostics information for a P1782 trouble code related to the transfer L4 position switch for an automatic transmission. It indicates that the switch is remaining on. The circuit description notes that the ECM detects the signal from the switch. Inspection procedures include checking for voltage at the switch connector terminal and between the terminal and the ECM to diagnose a short, faulty switch, control ECU or ECM as potential trouble areas.

Uploaded by

limadacarlos
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

05-498 DIAGNOSTICS - ELECTRONIC CONTROLLED AUTOMATIC

TRANSMISSION [ECT] (A750E/A750F) 05A2X-01

DTC P1782 T/F L4 RANGE POSITION SWITCH


PERFORMANCE

CIRCUIT DESCRIPTION
The ECM detects the signal from the transfer L4 position switch.
This DTC indicates that the transfer L4 position switch remains ON.
DTC No. DTC Detecting Condition Trouble Area
Transfer L4 position switch remains ON while vehicle running
under conditions for 18 seconds or more (1-trip detection log-  Short in transfer L4 position switch circuit
P1782 ic)  Four wheel drive control ECU
(a) Output shaft speed 3000 rpm or less  ECM
(b) Transfer shift position is H

WIRING DIAGRAM

4WD Control ECU ECM

J30
J/C
24 4
W-L H H W-L
L4 F9 E7 L4

G22673

2003 4RUNNER REPAIR MANUAL (RM1001U)

Author: Date: 676


DIAGNOSTICS - ELECTRONIC CONTROLLED AUTOMATIC 05-499
TRANSMISSION [ECT] (A750E/A750F)

INSPECTION PROCEDURE
1 INSPECT TERMINAL VOLTAGE(L4 - BODY GROUND)

(a) Disconnect the four wheel drive control ECU connector.


(b) Turn the ignition switch ON.
(c) Measure the voltage between terminal L4 of four wheel
drive control ECU and body ground.
OK:
Voltage: 10 - 14 V

OK CHECK AND REPLACE FOUR WHEEL DRIVE


L4 C95382 CONTROL ECU (See page 01-35 )

NG

2 INSPECT TERMINAL VOLTAGE(L4 - E1)

ON (a) Turn the ignition switch ON.


E1 L4 (b) Measure the voltage between terminal L4 and E1 of ECM.
OK:
Voltage: 10 - 14 V

G20666
OK REPAIR OR REPLACE HARNESS OR
CONNECTOR (See page 01-35 )

NG

CHECK AND REPLACE ECM (See page 01-35 )

2003 4RUNNER REPAIR MANUAL (RM1001U)

Author: Date: 677

You might also like