STEP-BY-STEP Penile Traction System –

STEP-BY-STEP Penile Traction System –

Green Diaphragm: Small glans penis

1 2 3 4

Turn the rotary valve Spread 3-4 drops of Spread 3-4 drops of Pro- • Squeeze the pump ball
counter-clockwise to close. Pro-Master fluid to the Master fluid to the inside of almost entirely.
1 2 3 glans penis. the latex. • Attach the squeezed
Green Diaphragm: Small glans penis
pump ball (marks on
Yellow Diaphragm: Medium glans penis
plastic are above) to the
Turn the rotary valve counter- Spread 3–4 drops of Pro-Master Spread 3–4 drops of Pro-Master fluid Blue Diaphragm: Large glans penis
closed rotary valve.
clockwise to close. fluid to the glans penis. to the inside of the latex.

5 6 7 8

• Turn the glans chamber Slowly release your squeeze. Turn the pump ball counter- • Adjust the belt length to
and pump ball against This creates a gentle clockwise to disengage from your body size.
4 5 6 each other. vacuum that pulls the glans the rotary valve. Keep the • Lower the traction to the
• Squeeze the pump ball inside the chamber. valve closed. penis by elongating the
to the limit. TIP: If the glans is not belt.
• Squeeze the pump ball almost • Turn the glans chamber and pump Slowly release your squeeze. This • Push the glans softly • Increase the traction to
entirely. ball against each other. creates a gentle vacuum that pulls sucked into the chamber
against the glans chamber. completely, go on to step 7. the penis by shortening
• Attach the squeezed pump ball • Squeeze the pump ball to the limit. the glans inside the chamber. the belt.
(marks on plastic are above) to the • Push the glans softly against the Then repeat steps 4 and 6.
TIP: If the glans is not sucked into
closed rotary valve. glans chamber. the chamber completely, go on to
step 7. Then repeat steps 4 and 6.

O
R

9 10 11 10

• Clip the narrow section on • Put the penis left or right • Wrap the belt around your • Put the penis upwards.
the coupling socket. towards your hip. back and turn it around • Put the belt over your
• Pull the belt for coupling. your thigh. shoulder
• Fix the belt with the clip
at a ring or directly at the
7 8 9 10 belt.

Turn the pump ball counter- Set up the rod extender Insert the engaged • Press-in the rods. O
clockwise to disengage system. Estimate the penis inside the rod • Gently stretch the penis to clip the R
from the rotary valve. length of the system extender system. narrow section on the coupling socket.
Keep the valve closed. (your extended penis • Control traction with spring balance.
size + 1.5 cm or .6 in). Lower traction using shorter rods.
Increase traction using longer rods
or threaded screws.
11 10 11 12
Control traction with spring balance:
Emser Straße 39 d · 10719 Berlin, Germany
• About 230 grams per mark.
www.penimaster.de · [email protected] • Cross the belt over your • Sit on a chair. Wrap the free end of the Fix the belt with the clip at
• Lower traction using shorter rods.
Telephone: +49 (0)30/23 63 85 64 back. • Wrap the belt around belt around the part of the a ring.
• Increase traction using longer rods
Fax: +49 (0)30/21 75 26 11 • Fix the belt with the clip a knee. belt that is engaged to the
or threaded screws.
at your trousers. penis.