Scribd
Upload
33 views1 page

Experiment: Heat Treatmeant Process Title: Metallographic Sample For Microstructures & Heat Treatmeant Process Duration: 2 Hours

The document describes the procedure for preparing a metallographic sample for microscopic analysis and heat treatment processes. The 10 step procedure involves cutting a specimen to size using an abrasive cutter, ensuring safety precautions are followed such as checking the cutter condition and wearing protective gloves. The overall goal is to prepare a sample that can be used to examine microstructures and analyze the effects of heat treatment.

Uploaded by

Hasmittha
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
33 views1 page

Experiment: Heat Treatmeant Process Title: Metallographic Sample For Microstructures & Heat Treatmeant Process Duration: 2 Hours

The document describes the procedure for preparing a metallographic sample for microscopic analysis and heat treatment processes. The 10 step procedure involves cutting a specimen to size using an abrasive cutter, ensuring safety precautions are followed such as checking the cutter condition and wearing protective gloves. The overall goal is to prepare a sample that can be used to examine microstructures and analyze the effects of heat treatment.

Uploaded by

Hasmittha
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

DJJ 30113 Material Science& Engineering

EXPERIMENT : HEAT TREATMEANT PROCESS

TITLE : METALLOGRAPHIC SAMPLE FOR MICROSTRUCTURES & HEAT


TREATMEANT PROCESS

DURATION : 2 HOURS

PAGE : 1 0F 10

VISAL A/L RAKUNATAN


16DKM19F2014

Procedure
1) The specimen is marked to be cut out size 10mm x 10mm x 7mm.
2) The cover of the machine is lifted.
3) The specimen is placed in a vise and is locked with a lever, the cutter is moved to accurately
cut the marked specimen. If inaccurate, re position the specimen.
4) The cover is closed and the power is switched ON.
5) The lights is switched on so that the cutting process can be seen.
6) The green button is pressed to ON the motor and the coolant also is turned ON.
7) To cut the specimen the process is started by pressing the lever down. The cutting pressure is
made sure to applied carefully to prevent wheel breakage.
8) After finish, the motor is stopped by pressing the red button (STOP button).
9) The cover is opened and specimen is removed.
10) The power supply is turned OFF.

Safety Precautions
1) The abrasive cutter is made sure to be in good condition before used.
2) Do not switch on the power supply with a wet hand.
3) Wear protective equipment such as gloves.

You might also like