The Trainer template for: Copyright © 2015 TailorToys L.L.C. All rights reserved.

PowerUp® is a trademark of TailorToys L.L.C.

PowerUp 3.0; PowerUp Free Flight (2.0)
Paper type - 80 to 100 GSM www.poweruptoys.com
Paper size - A4
Printer Setting - Scale 100% borderless
Designed by John Collins

Elevator Rudder Rudder Elevator

The Trainer template for: Copyright © 2015 TailorToys L.L.C. All rights reserved.
PowerUp® is a trademark of TailorToys L.L.C.
PowerUp 3.0; PowerUp Free Flight (2.0)
Paper type - 80 to 100 GSM www.poweruptoys.com
Paper size - A4
Designed by John Collins

Designed by John Collins

Printer Setting - Scale 100% borderless
Paper size - A4
Paper Type - 80 to 100 GSM
PowerUp 3.0; PowerUp Free Flight (2.0)
The Trainer template for:

Designed by John Collins

Printer Setting - Scale 100% borderless
Paper size - A4
Paper Type - 80 to 100 GSM
PowerUp 3.0; PowerUp Free Flight (2.0)
The Trainer template for:
Elevator

Elevator
Rudder

Rudder
Rudder

Rudder
www.poweruptoys.com
PowerUp® is a trademark of TailorToys L.L.C.
Copyright © 2015 TailorToys L.L.C. All rights reserved.

www.poweruptoys.com
PowerUp® is a trademark of TailorToys L.L.C.
Copyright © 2015 TailorToys L.L.C. All rights reserved.
Elevator

Elevator

1. Start with the printed template 2. Fold the left side to the mark 3. Fold the lower right corner along
face up. Fold in half, the lower line and unfold. the marked crease line.
edge to the top edge. Unfold. Turn over the paper.

The Tra The Tra

Powe iner templa PowerU iner templa
Paper
rUp 3.0
;
te for Paper p 3.0; Pow te for: www.
Type PowerUp : Type erUp
power
Paper - Free Flig
Paper -
size - 80 to 100
Free Flig size - 80 to 100
PowerU
uptoys ht (2.0
Printe US let GSM ht (2.0
Copyrig p® is a trad
Printe US lett GSM )
r
.com
) Desig Setting - Scaer
ht © 201 emark
r ter
Desig Setting - Sca
5 TailorToof TailorToy
ned by
ned by John le 100% bo
ys L.L.C s L.L.C
John le 100% bo
. All righ .
Collin Collin rderles ts rese
s rderle s s
rved
ss
.

4. Fold the upper right corner 5. Bring the sharp corner to 6. Bring the red edge to the
along the marked crease line, the grey dot location (the grey center line (red dotted line).
and cover the lower flap. dot is printed on the other
side!)

7. Repeat on the other 8. Lock the flaps with the 9. Fold the model in half
edge. small triangle. through the center line.

10-11
Elevator

Elevator
Rudder

Rudder
Elevator

Elevator

10. Fold the wing 11. Fold the wing tip up, 12. Repeat steps 10-11 13. Spread the wings.
down along the along the crease line on the other side. Cut the elevators and
marked crease line. (printed on the other side). rudder.
Your Trainer is ready!