Scribd
Upload
2K views

Simocom U Configuring Details....

The document provides instructions for commissioning drives and motors using the SIMOCOM U tool. The steps include opening the SIMOCOM U software, searching for online drivers, configuring the drive name and axis, setting the Profibus address, motor type, encoder settings, operating mode, and calculating and saving control data to commission the drive.

Uploaded by

igormarkes
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2K views

Simocom U Configuring Details....

The document provides instructions for commissioning drives and motors using the SIMOCOM U tool. The steps include opening the SIMOCOM U software, searching for online drivers, configuring the drive name and axis, setting the Profibus address, motor type, encoder settings, operating mode, and calculating and saving control data to commission the drive.

Uploaded by

igormarkes
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 8

Drive and Motor Commissioning with SIMOCOM U tool

1) Open SIMOCOM U tool and search for the online drivers

- 117 -
SIMOCOM-U CABLE CONFIGURATION

- 118 -
1) Open Simocom U Software and Search for the online drivers.

2) After search for Online Drivers is done. Below Screen Start-up required screen appears

- 119 -
3) Select Drive Configuration screen and configure the Drive name which axis you’re going to configure.

4) Select the Profibus Address for the specific drive…example is mentioned for the further references

- 120 -
5) Select the Power section of the Respective axis for example Spindle (50A)

- 121 -
6) Select the respective motor (X, Z, Sp) for example Spindle motor type no mentioned below.

7) Select the Measuring system/encoder Standard Encoder 2048 lines/rev


(For ex: SP Std encoder 2048 for X,Z axis selection is available Std Encoder(2048) as well Absolute
Endat(2048))

- 122 -
8) Operating Module I what mode do you wish to operate this drive: SPEED/ TORQUE SETPOINT?

9) Spindle doesn’t have Second Encoder select NO ENCODER. If Encoder is there Select Encoder.

- 123 -
10) Select Calculate Control Data, Save, rest

11) After selecting Calculate Control Data. Drive information’s data get stored

- 124 -

You might also like