Scribd
Upload
44 views7 pages

Module 1 Ethernet and VLAN

The document discusses configuring Ethernet interfaces and link aggregation on Huawei switches. It includes manually setting interface speeds, configuring static and LACP link aggregation, and setting interface and system priorities for link aggregation.

Uploaded by

wissalwissou
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
44 views7 pages

Module 1 Ethernet and VLAN

The document discusses configuring Ethernet interfaces and link aggregation on Huawei switches. It includes manually setting interface speeds, configuring static and LACP link aggregation, and setting interface and system priorities for link aggregation.

Uploaded by

wissalwissou
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 7

Module 1 Ethernet and VLAN

Lab 1-1 Ethernet Interface and Link Configuration

Learning Objectives

As a result of this lab section, you should achieve the following tasks:
 Manually set the line rate on an interface.
 Configuration of manual mode link aggregation.
 Configuration of link aggregation using static LACP mode.
 Management of the priority of interfaces in static LACP mode.

Topology

Tasks

Srep1 Perform basic configuration on the Ethernet switches

Auto-negotiation is enabled on Huawei switch interfaces by default. The rate of


G0/0/9 and G0/0/10 on S1 and S2 are to be set manually.
Change the system name and view detailed information for G0/0/9 and G0/0/10
on S1.
Set the rate of G0/0/9 and G0/0/10 on S1 to 100 Mbit/s. Before changing the
interface rate, disable auto-negotiation.

Set the rate of G0/0/9 and G0/0/10 on S2 to 100 Mbit/s.


Confirm that the rate of G0/0/9 and G0/0/10 have been set on S1.
Step2 Configure manual link aggregation

Create Eth-Trunk 1 on S1 and S2. Delete the default configuration from G0/0/9
and G0/0/10 on S1 and S2, and then add G0/0/9 and G0/0/10 to Eth-Trunk 1.

Verify the Eth-Trunk configuration.


The greyed lines in the preceding information indicate that the Eth-Trunk works
properly.
Step3 Configuring Link Aggregation in Static LACP Mode

Delete the configurations from G0/0/9 and G0/0/10 on S1 and S2.

Create Eth-Trunk 1 and set the load balancing mode of the Eth-Trunk to static
LACP mode.

Verify that the LACP-static mode has been enabled on the two links.
Set the system priority on S1 to 100 to ensure S1 remains the Actor.

Set the priority of the interface and determine active links on S1.

Verify the Eth-Trunk configuration.

Final Configuration

You might also like