Scribd
Upload
59 views

Attempt All Sections. If Require Any Missing Data Then Choose Suitably

This document is the question paper for a Basic Electronics exam consisting of 7 sections with multiple choice and numerical problems. Some of the key topics covered include: 1. Operational amplifiers, BJT characteristics, advantages of digital instruments, ideal op-amp characteristics, modulation index, transconductance. 2. Full wave rectifier circuits, common emitter characteristics, op-amp applications as an integrator, inverting summer, and voltage follower. 3. Zener diode circuit analysis, tunnel diodes, transistor characteristics, operational amplifier configurations. The exam tests knowledge of fundamental electronics concepts through calculations and explanations of circuits, devices, and systems.

Uploaded by

pcjoshi02
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
59 views

Attempt All Sections. If Require Any Missing Data Then Choose Suitably

This document is the question paper for a Basic Electronics exam consisting of 7 sections with multiple choice and numerical problems. Some of the key topics covered include: 1. Operational amplifiers, BJT characteristics, advantages of digital instruments, ideal op-amp characteristics, modulation index, transconductance. 2. Full wave rectifier circuits, common emitter characteristics, op-amp applications as an integrator, inverting summer, and voltage follower. 3. Zener diode circuit analysis, tunnel diodes, transistor characteristics, operational amplifier configurations. The exam tests knowledge of fundamental electronics concepts through calculations and explanations of circuits, devices, and systems.

Uploaded by

pcjoshi02
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Printed pages: 03 Sub Code: REC101

Paper Id: 3 0 0 1 Roll No:


B.TECH
(SEM 1) THEORY EXAMINATION 2017-18
BASIC ELECTRONICS

Time: 3 Hours Total Marks: 70


Notes:
1. Attempt all Sections. If require any missing data; then choose suitably.
2. Any special paper specific instruction.

SECTION A

1. Attempt all questions in brief. 2 x 7 = 14


A. An operational amplifier has a differential gain of 103 and 100, input voltages are 120µV and 80µV,
and determine output voltage.
B. What is ripple factor? What is the value of RF for half wave and full wave rectifier?
C. Why BJT is called current controlled device?
D. State the advantage of digital instruments over analog instruments.
E. List the ideal characteristics of op-amp.
F. What is modulation index? Draw the amplitude spectrum of AM wave.
G. What is trans-conductance in FET? What is the relationship between gm and gmo?

SECTION B

2. Attempt any three of the following: 7 x 3 = 21


A. Explain the following with clear diagram:-
i) Full wave voltage doubler.
ii) Bridge rectifier.
B. Draw the common emitter circuit and sketch the input and output characteristics. Also explain active
region, cutoff region and saturation region by indicating them on the characteristic curve.
C. Explain how Op-Amp can be used as
i) Integrator ii) Inverting Summer and iii) Voltage Follower
D. Explain with block diagram how DMM can measure AC and DC signals and various other electrical
parameters?
E. Draw the block diagram of communication system. Calculate the percentage power saving when one
side band and carrier is suppressed in an AM signal with modulation index equal to 1.
SECTION C
3. Attempt any one part of the following: 7x1=7
1)
A) Determine the range of Vi for the fig. that will maintain the zener diode in “ on ” state?

B) Determine vo for the circuit shown in fig

2) Explain the following:-


A) Tunnel Diode
B) Transition capacitance and diffusion capacitance
4. Attempt any one part of the following: 7x1=7
1) For the network of fig.
a) Determine RB and RE
b) Find VB, VCE, and VBC

2)
A) Explain the construction and working of N-channel JFET. Draw the drain characteristic and
transfer curve.
B) Explain the construction and working of depletion MOSFET.
5. Attempt any one part of the following: 7x1=7
1)
A) Calculate the output voltage Vo of the circuit.

B) Explain the following characteristics of an op-amp:-


i) CMRR
ii) slew rate
2) Derive an expression for voltage gain of inverting and non-inverting ideal operational amplifier
configurations.
6. Attempt any one part of the following: 7x1=7
1) Draw and explain the block diagram of a ramp-type digital voltmeter (DVM).
2) A) Draw the general block diagram of CRO and explain each block.
B) A Lissajous pattern on an oscilloscope is stationary. It has 5 vertical tangent values and 6
horizontal tangent values. The frequency of horizontal input is 1800Hz. Determine the frequency of
vertical input.

7. Attempt any one part of the following: 7x1=7


1) Define Amplitude Modulation. Derive the expression for AM modulated waveform. Define modulation
index of AM.
2) A certain AM transmitter radiates 9 KW with the carrier unmodulated and 10.125 KW when the carrier
is modulated. Calculate the modulation index. If another sine wave is simultaneously transmitted with the
modulation index 0.4, determine the total radiated power.

You might also like