Scribd
Upload
180 views

FortiNAC - VM Running

The document provides step-by-step instructions for configuring a FortiNAC appliance using the configuration wizard. It includes steps like setting the IP address, obtaining the license file, configuring basic network settings like passwords and network type, configuring the isolation interface and additional routes, reviewing the configuration summary, applying the settings, and rebooting the FortiNAC appliance.

Uploaded by

Testew asa
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
180 views

FortiNAC - VM Running

The document provides step-by-step instructions for configuring a FortiNAC appliance using the configuration wizard. It includes steps like setting the IP address, obtaining the license file, configuring basic network settings like passwords and network type, configuring the isolation interface and additional routes, reviewing the configuration summary, applying the settings, and rebooting the FortiNAC appliance.

Uploaded by

Testew asa
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 22

FortiNAC

Configuration Wizard
Vmware - ova
FortiNAC - Set the IP address for eth0

sudo configIP 10.254.1.200 255.255.255.0 10.254.1.1


PDF da licença !
Connect to configWizard on:
https://<ipaddress>:8443/configWizard
user: config
pass: config

clique

Copy
Paste
Open lic file, copy
content and paste

Click OK to start
Configuration
FortiNAC - configWizard
• Click OK to continue.
FortiNAC - configWizard: Basic Network
• ‘OK’ the Download Documentation Section and Configure Basic Network
FortiNAC - configWizard: Network Type
• Change ‘Passwords’ if required and move on to Network Type and Select Layer 3
FortiNAC - configWizard: Layer 3 Isolation
• Configure Isolation Interface eth1 Note: You don’t need to add all scopes. Add only the
scope which represents your Isolation network.
FortiNAC - configWizard: Additional Routes
• Leave the rest of the configuration blank, just click ’Next>>’ until you reach the ‘Additional
Routes’ Menu and configure and confirm the settings below

Note: You don’t need to add all routes. Just confirm if the route which represents your Isolation network is here.
FortiNAC - configWizard: Summary
• Confirm the settings under
Summary and hit ‘Apply’
• GUI will pause for a few
seconds but should return
and without errors
• This completes the
configWizard
• This will reboot FortiNAC

You might also like