8200A-Audiolab Service Manual V01
8200A-Audiolab Service Manual V01
VERSION HISTORY
8200A
CONTENT
1. Introduction 1
2. Specification 2
3. Assembly Sketch 3
4. Schematic Diagram 4-16
5. Wiring Diagram 17
6. Silkscreen of Top/Bottom 18-20
7. Maintenance Alignment Procedure 21
8. Assembly Parts List 22-23
9. Electronic Parts List 24-31
8200A
INTRODUCTION
No part of this document may be reproduced or transmitted in any form or by any means,electronic or
mechanical, for any purpose, without the express written permission of International Audio Group
Limited (IAG)
This manual is for the exclusive use of IAG, its approved distributors and approved UK service agents.
No part of this manual shall be transferred to any other party without the express written permission of
IAG.
It is the responsibility of the user to ensure that all the information contained in this manual is current.
Notification for new issues of this manual and minor updates will be given via the IAG web-site or on
request.
This manual has been prepared with the greatest care, it is intended for information only and no liability
shall be accepted for errors or changes to specification.
For further service information, parts lists and updates, please contact our web-site at
www.international audio group.com .
1
8200A
SPECIFICATION
Rated Output Power 60W per channel into rated load impedance(8 Ohms)
with both channels driven
Inputs CD,TUNER,AUX,VIDEO,TAPE1,TAPE2:125mV/20kΩ IHF
POWER AMP:782mV/47KΩ
Gain PRE-AMP:9dB@1kHz
POWER AMP:29.0dB@1kHz
Signal To Noise Ratio CD,TUNER,AUX,VIDEO,TAPE1,TAPE2:
Better than 80dB(IHF,rel.0.5V pre-amp output)
POWER AMP:better than 80dB(IHF,rel.0dBW)
CD,TUNER,AUX,VIDEO,TAPE1,TAPE2 and POWER
Frequency Response
AMP:
20Hz-20kHz±0.5dB:1Hz-65kHz-3dB.
Total Harmonic Distortion & Noise Less than 0.07%
Channel Balance Within 1dB
Channel Separation Better than 60dB@1kHz any input
Crosstalk Better than 80dB@1kHz
Polarity(phase) Non-inverting for all inputs and outputs
Pre-amp Output PRE OUT1 and PRE OUT2:Output Impedance 100Ω
Maximum Output>7.3V RMS
Headphone Output Output impedance:330Ω
(suitable for headphones8Ω-2kΩ impedance)
Record Output VIDEO OUT,TAPE1 OUT,TAPE2 OUT:
Output impedance:1kΩ
Gain from input to record output 0dB(x1)
Muting Muting controlled manually or automatically
Accessories Supplied AC Power Cord
Instruction Manual
8200RC Remote Control with 2xAA batteries
Operating Temperature Range 10-35℃
Power Requirements(Depending on Region) 50-60Hz 100V,110-120V,and220-230V models available
Maximum Power Consumption:440VA
Dimensions(WxHxD) 445x74x335mm-including feet,terminals and controls
445x64x302mm-excluding feet,terminals and controls
Weight Net:7.4kg
Shipping:8.8kg
2
8200A
ASSEMBLY SKETCH
14
29
41
41
28
27
41
26
41
42
25
24
23
40
19 20 21 10
39
38 18
37
36
35
34
33
32
31 8
30
22
17
14
12
11 14
10
9 13
8
7 14
4
3 43
15 44
2 5
16
1 6
3
8200A
SCHEMATIC DIAGRAM
8200A-Mainboard-P1/12
4
8200A
SCHEMATIC DIAGRAM
8200A-Mainboard-P2/12
5
8200A
SCHEMATIC DIAGRAM
8200A-Mainboard-P3/12
6
8200A
SCHEMATIC DIAGRAM
8200A-Mainboard-P4/12
7
8200A
SCHEMATIC DIAGRAM
8200A-Mainboard-P5/12
8
8200A
SCHEMATIC DIAGRAM
8200A-Mainboard-P6/12
9
8200A
SCHEMATIC DIAGRAM
8200A-Mainboard-P7/12
10
8200A
SCHEMATIC DIAGRAM
8200A-Mainboard-P8/12
11
8200A
SCHEMATIC DIAGRAM
8200A-Mainboard-P9/12
12
8200A
SCHEMATIC DIAGRAM
8200A-Mainboard-P10/12
13
8200A
SCHEMATIC DIAGRAM
8200A-Mainboard-P11/12
14
8200A
SCHEMATIC DIAGRAM
8200A-Mainboard-P12/12
15
8200A
SCHEMATIC DIAGRAM
8200A IR-Receiver-P1/1
16
8200A
WIRING DIAGRAM
17
8200A
SILKSCREEN OF TOP /BOTTOM
18
8200A
SILKSCREEN OF TOP /BOTTOM
19
8200A
SILKSCREEN OF TOP /BOTTOM
20
8200A
MAINTENANCE ALIGNMENT PROCEDURE
Remarks:Also the test continues unil the bias is steady at the final value in the table.
1.If the Bias Okay, switch off the unit and put "PASSED" mark on the unit.
21
8200A
ASSEMBLY PARTS LIST
8200A-Assembly Bom-P1/2
22
8200A
ASSEMBLY PARTS LIST
8200A-Assembly Bom-P2/2
Remark:Colour DifferenceTable
R/P P/N PART NAME DESCRIPTION QTY
300-1027410000R screened, light grey(silver anodized) 1
1 front panel
300-1027420000R screened, light grey(black anodized) 1
215-1027410001R silver painted,ABS757# 1
3 button cap
215-1027420001R black painted,ABS757# 1
340-1027410000R silver painted 4
4 knob
340-1027420000R black painted 4
307-1027410000R silver painted,φ6.0 L=24MM 4
5 knob indicator
307-1027410000R black painted,φ6.0 L=24MM 4
215-1027410000R silver painted,ABS757# 1
7 power button
215-1027420000R black painted,ABS757# 1
534-3002061006R M3*6NI 23
14 screw
534-3002060906R M3*6 black 33
604-1027410002-1R silver painted 1
15 chassis
604-1027420004-2R black painted 1
319-1027410001R sand blasting,anodized silver 2
17 side panel
319-1027420001R sand blasting,anodized black 2
588-3000106037R M3*10NI 8
23 screw
527-3012100806R M3*10black 8
302-1027410002R sand blasting,anodized silver 1
29 top cover
302-1027420000R sand blasting,anodized black 1
534-3002100606R M3*10NI 4
41 screw
534-3002100906R M3*10black 11
303-1027410000R silver painted 1
44 bottom cover
303-1027420000R black painted 1
23
8200A
ELECTRONIC PARTS LIST
PCB of SPEAKER
17 053-1377001137QR 150*52MM 1
OUTPUT
18 088-1027411000R AMP PCB assembly 8200A PCBA 1
19 001-1000205010QR resistor 10R 1/4W 1% 4 R736.738.836.838
20 001-1500205010QR resistor 15R 1/4W 1% 2 R517.617
R512.515-516.612.615-
616.708.723.726.746-
21 001-4700205010QR resistor 47R 1/4W 1% 16
747.808.823-
826.846.847
24
8200A
ELECTRONIC PARTS LIST
R510.610.663.751-
30 001-1004205010QR resistor 100K 1/4W 1% 11 752.851-
852.951.958.961.963
R702.741-742.802.841-
31 001-4703205010QR resistor 47K 1/4W 1% 8
842.956.964
R712.739-740.812.839-
32 001-1503205010QR resistor 15K 1/4W 1% 10
840.902.905.914.916
R908.705.706.715.716.7
44 001-6801205010QR resistor 680R 1/4W 1% 13 32.734.805.806.815.816
.832.834
R301.711.717-
46 001-1002205010QR resistor 1K 1/4W 1% 14 718.811.817-818.866-
871.953
R664.860-
864.949.959.965.R304-
47 001-1003205010QR resistor 10K 1/4W 1% 36 311.320-
327.329.337.400-
405.407.408.661
25
8200A
ELECTRONIC PARTS LIST
R300.504.509.604.609.7
52 001-4702205010QR resistor 4K7 1/4W 1% 11
03.803.906.910.917.952
D946-
951.953.D301.502.504-
507.602.604-
68 067-1104148000R DIODE IN4148 62 607.661.701-709.715-
716.727-
728.801.809.815-
816.827-828.
D400-408.717-718.817-
70 067-3379629000QR ZENER DIODE DIODE BZX79C 6V2 ZENER 20 818.870-
873.903.905.945
26
8200A
ELECTRONIC PARTS LIST
Q713.813.931-932.935-
77 018-2700042115QR transistor TRAN ZTX457 NPN TO-92 6
936
78 018-2800310115QR transistor TRAN J310 N-CH FET TO-92 1 Q947
79 018-2700092115QR transistor TRAN ZTX757 PNP E-Line 4 Q714.814.933-934
R313-314.318-
98 001-0220205014QR resistor 2.2R,0.25W,1% 7
319.340.974.977
27
8200A
ELECTRONIC PARTS LIST
28
8200A
ELECTRONIC PARTS LIST
130 016-4740810001R POLYSTYRENE CAP 0U47 10% 63V MKS2 WIMA PH5MM 1 C938
131 016-1041300001R POLYSTYRENE CAP 0.10uf 250v 5% PH=10MM WIMA 1 C901
132 016-3331100001R POLYSTYRENE CAP 0U033 5% 100V MKS2 WIMA PH5MM 4 C931-934
C302.305-307.313-
318.506.606.709-
133 016-1041100001R POLYSTYRENE CAP 0U1 5% 100V MKS2 wima ph5mm 24 711.809-
811.907.910.915.935.96
2.964
141 013-4730320504QR CAP CAP 47000P 20% 100V X7R CER 2 VR660
142 306-1003770011QR mian heatsink anodized 1
143 306-1003770001QR heatsink 1 anodized 1
144 306-1003770002QR heatsink 2 anodized 1
145 306-1003770003QR heatsink 3 anodized 2
146 306-1027410005R heatsink 5 anodized, black 4
147 306-1027410006R heatsink 6 anodized, black 4
148 306-1027410003R heatsink anodized, black 2
149 306-1027410001R heatsink 1a anodized, black 1
150 306-1027410002R heatsink 2a anodized, black 1
151 306-1027410000R T type heatsink anodized, black 1
transistor+mian
152 588-3000256037R screw M3*25 4
heatsink4
transistor+mian
153 500-3050240300AR nut M3 NI 5
heatsink4,T type
transistor+mian
154 513-3007050080R washer φ3*φ7*0.5 Zn 4
heatsink4
29
8200A
ELECTRONIC PARTS LIST
transistor+mian
155 517-3008080130AR washer Φ3.1*Φ4.7*0.8 4
heatsink4
R941-
944.R709.710.727.728.7
159 001-4701205010QR resistor 470R 1/4W 1% 16
55.809.810.827.828.855
.935.936
Q660-662.705-
706.708.719.721.805-
162 018-1400546115-1R transistor BC546BRL1G TO-92 ON 23 806.808.819.Q821.902-
903.905-906.910-
911.939.941.943.945
164 223-0414210201R plastic standoff white ABS PW-6 height 2mm 2 X300
165 053-102741A000R 8200A-AMP PCB two layer 407.7*294.6*2.0MM 1
SOCKET 4WAY PHONO GOLD
166 051-1006334035-1R SOCKET PLATED T6288-AABF up white/down 5 J860-863
red
167 060-4120210012R 12AWG WIRE red UL1617AWG L=215MM 1
168 060-4120120512R 12AWG WIRE white UL1617AWG L=125MM 1
169 060-4120150012R 12AWG WIRE red UL1617AWG L=155MM 1
170 060-4120180512R 12AWG WIRE white UL1617AWG L=185MM 1
heatsink 1a-1,heatsink
171 588-3000086037R screw M3*8 6 5 4,heatsink 2a-1,
heatsink
mian heatsink+AMP
172 588-3000066037R screw M3*6 4
PCB
30
8200A
ELECTRONIC PARTS LIST
31
8200A