0% found this document useful (0 votes)
200 views

MCM25/EV: (Radio Receiver Am/Ssb/Fm/ Remote Control)

The document summarizes an experiment board called MCM25/EV that is used to study AM, DSB, SSB, FM receivers and radio control receivers. The board contains all the necessary electronic components to construct the receiver circuits and can be used in standard mode with switches or in computerized mode connected to control software. It allows experiments on topics like radio reception, signal strength measurement, local oscillators, PLL circuits, and troubleshooting receiver circuits. The board has inputs for antennas, connections for a control unit and power supply, and printed circuitry with a diagram.

Uploaded by

lusoegyi 1919
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
200 views

MCM25/EV: (Radio Receiver Am/Ssb/Fm/ Remote Control)

The document summarizes an experiment board called MCM25/EV that is used to study AM, DSB, SSB, FM receivers and radio control receivers. The board contains all the necessary electronic components to construct the receiver circuits and can be used in standard mode with switches or in computerized mode connected to control software. It allows experiments on topics like radio reception, signal strength measurement, local oscillators, PLL circuits, and troubleshooting receiver circuits. The board has inputs for antennas, connections for a control unit and power supply, and printed circuitry with a diagram.

Uploaded by

lusoegyi 1919
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

INTRODUCTION

MCM25/EV
MCM25/EV is one of the experiment boards that constitute the
Interactive Practical Electronics System – I.P.E.S.

BT
It consists of a set of components and circuits for performing
experiments.
(RADIO RECEIVER The lessons included in this module can be developed in:

AM/SSB/FM/ - Standard mode: using the switches of the equipment and


consulting the handbook;
REMOTE CONTROL) - Computerized mode: the interactive software version of
the handbook - SW-D-MCM25/EV - interfaced to the module
via Control Unit SIS3-U/EV, is used. This software inserts circuit
variations and faults automatically enabling the development
of lessons even without teacher’s assistance.

MCM25/EV
Experiment board for the study of AM, DSB, SSB (LSB and USB),
FM receiver and a 4-channel radio control receiver. It contains
all the pre-assembled electronic components needed to
construct the experiment circuits and divided into functional
blocks which can be interconnected and modified by means of
supplied jumpers and connection cables.
Experiment boards MCM24/EV and MCM25/EV can be used
together to set up a radio communication link.

TRAINING PROGRAM:
TELECOMMUNICATIONS AND TELEMATICS

• Block diagram of a superheterodyne receiver


• Demodulation techniques for AM, DSB, SSB, FM and
• LF amplifier: power of 1 W with volume control
logic states transmissions
• Loudspeaker included
• Radio (antenna)/cable reception
• Fault simulation: 10 faults can be inserted
• Received signal field strength meter
• Interconnection and test points with Ø 2 mm
• Received code meter from radio control via Led
• Quick changes in circuits via Microswitches
• Local oscillator
• PLL Circuit (Phase Locked Loop) • 37-pin connector for connection with control unit SIS3-U/EV
• Frequency synthesis with PLL • 8-way connector for connection with power supply unit
• Carrier suppressor regeneration • Printed circuit with protective coating and silk-screen-
• Change of tuning frequency printed synoptic diagram
• IF conversion mixer • Module equipped with ABS protection on its lower side
• IF filter
• IF amplifier Dimensions: 386 x 248 x 60 mm
• AGC (Automatic Gain Control)
• Output AF amplifier REQUIRED
• Calibration and measurement of all stages and the
whole module PSLC/EV
POWER SUPPLY
• Troubleshooting POWER SUPPLY UNIT
- NOT INCLUDED - +12 Vdc - 0.5A
• System test and measurement
• Use of the spectrum analyzer

MCM24/EV - NOT INCLUDED -


TECHNICAL SPECIFICATION: (RADIO TRANSMITTER
AM/SSB/FM/REMOTE CONTROL)
• AM/DSB receiver in Medium Wave (MW) band
• SSB receiver in 80-m SW band (3-4 MHz)
• FM receiver in Medium Wave (MW) band INCLUDED
• Radio-control receiver in Medium Wave (MW) band STUDENT HANDBOOK: THEORY AND EXERCISES
• Decoder: 9 output lines (4 Data lines and 5 Address lines) TEACHER HANDBOOK:
• 2 Local Oscillators: manual frequency control (direct SOLUTIONS OF EXERCISES
voltage variation) or automatic frequency control (PLL
frequency synthesis) OPTIONAL
• Warning LEDs: 2 LEDs for PLL lock, 1 LED for tuning, 1 LED
21C-E-BT -MCM25-0

for valid Coding and 1 LED bar for the intensity of received PERSONAL COMPUTER
signal
• Characteristic of IF/RF test points: low impedance (50 Ω),
compatible for connection with spectrum analyzer FAULT INSERTION UNIT SIS3-U/EV AND
• MW band tuned receiving antenna of ferrite MULTIMEDIA SOFTWARE SW-D-MCM25/EV
• Input BNC connector for outdoor antenna or cable

ELETTRONICA VENETA S.P.A. - 31045 Motta di Livenza (TV) Italy - Via Postumia, 16 - Tel. +39 0422 765 802 - Fax +39 0422 861 901 - E-mail: [email protected] BT 21

You might also like