Scribd
Upload
49 views

Bulletin #D19E

This document provides countermeasures for abnormal noise coming from flexible couplings caused by wear between isolation rubber and inertia plates. It recommends modifying the isolation rubber and using a special spacer if the inertia plate hole has no wear. For inertia plates with excessive wear, it recommends re-boring the hole and using a modified isolation rubber and special spacer. Diagrams of the proposed modifications are included.

Uploaded by

ΑΠΟΣΤΟΛΙΑ ΜΑΤΣΟΥΚΑ
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
49 views

Bulletin #D19E

This document provides countermeasures for abnormal noise coming from flexible couplings caused by wear between isolation rubber and inertia plates. It recommends modifying the isolation rubber and using a special spacer if the inertia plate hole has no wear. For inertia plates with excessive wear, it recommends re-boring the hole and using a modified isolation rubber and special spacer. Diagrams of the proposed modifications are included.

Uploaded by

ΑΠΟΣΤΟΛΙΑ ΜΑΤΣΟΥΚΑ
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Bulletin #D19 - English

Countermeasures against noise from flexible coupling


DSE9101

The following modification should be effective in solving


abnormal noise coming from the flexible coupling,
caused by wear on the fitting surface between isolation
rubber and inertia plate.

1. If the fitting hole of the inertia plate has no


wear:

a. Machine isolation rubber according to figure 1.

b. Fit the special spacer (figure 2) together with the


modified rubber (figure 1) onto the inertia plate.

c. The special spacer is available from Daihatsu.

Ordering details: Figure 1

G403420230Z ISOLATION RUBBER SPACER

Figure 2

2. If the fitting holes of the inertia plate require


rectification due to excessive wear:

a. Re-bore fitting hole of the inertia plate to


155 0 ~ +0.1mm (this is 5 mm oversize from original
diameter).

b. Machine isolation rubber according to figure 3.

c. Fit the special spacer (figure 4) together with the


modified rubber (figure 3) onto the inertia plate.

d. The special spacer is available from Daihatsu.

Ordering details:

W302850110Z ISOLATION RUBBER SPACER (4-


B) Figure 3
Figure 4

Legal Notice
Copyright 2000 by marine industrial concerns s.a..
All rights reserved. E-mail comments to Webmaster
Updated 09.11.2004

You might also like