Scribd
Upload
77 views

Asia Pacific College of Advanced Studies Instructions: General Instructions

1. The document provides instructions for solving 4 structural engineering problems involving beams, columns, and linkages. 2. It instructs students to copy the problem, draw figures, show calculations, and submit solutions using an APCAS template by July 17, 2021 at 12:00 AM. 3. The first problem involves determining support reactions and deflection for a propped cantilever beam using double integration and area moment methods.

Uploaded by

Joshua John Julio
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
77 views

Asia Pacific College of Advanced Studies Instructions: General Instructions

1. The document provides instructions for solving 4 structural engineering problems involving beams, columns, and linkages. 2. It instructs students to copy the problem, draw figures, show calculations, and submit solutions using an APCAS template by July 17, 2021 at 12:00 AM. 3. The first problem involves determining support reactions and deflection for a propped cantilever beam using double integration and area moment methods.

Uploaded by

Joshua John Julio
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

ASIA PACIFIC COLLEGE OF ADVANCED STUDIES

INSTRUCTIONS:
GENERAL INSTRUCTIONS:
1. COPY THE PROBLEM
2. DRAW THE FIGURE
3. SOLVE WHAT IS ASKED IN THE PROBLEM AND BOX YOUR FINAL ANSWER
4. SHOW YOUR SOLUTION
5. USE ENGINEERING LETTERING
6. USE APCAS TEMPLATE WHEN SUBMITTING YOUR ACTIVITY
7. ONE COLUMN ONLY FOR THE FORMAT OF SOLUTION
8. SUBMIT ON JULY 17, 2021 AT 12:00 AM
Weekly Output No. 5
PROBLEM 1 (15 pts)
The propped cantilever beam is a W150 x 37.1 steel section. Determine the support reactions and the
deflection at A. Using
a) Double Integration Method
b) Area Moment Method

Draw the shear and moment diagram and use E = 200 GPa and I = 22.2 x 106 mm4

PROBLEM 2 (20 pts)


Determine the support reactions of the propped cantilever beam using DIM and AMM. Draw also the shear
and moment diagram.

PROBLEM 3 (10 pts)


Column ABC has a uniform rectangular cross section and is braced in the xz plane at
its midpoint C. (a) Determine the ratio b/d for which the factor of safety is the same
with respect to buckling in the xz and yz planes. (b) Using the ratio found in part a ,
design the cross section of the column so that the factor of safety will be 3.0 when P
= 4.4 kN , L = 1 m, and E = 200 GPa .
PROBLEM 4 (5 pts)
The linkage is made using two A992 steel rods, each having a circular cross section. If each rod has a
diameter of 3/4 in., determine the largest load it can support without causing any rod to buckle. Assume
that the rods are pin connected at their ends.

You might also like