Scribd
Upload
28 views

5 Non-Disjunction: Status Leds

Uploaded by

Industrial It
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
28 views

5 Non-Disjunction: Status Leds

Uploaded by

Industrial It
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

1 Solution sheet: Non-disjunction with LOGO!

Learn

5 Non-disjunction
The learning card shows the Non-disjunction as a function block diagram (FBD) and as a
circuit diagram.
If a OR-function and a NOT-function are interconnected, all output states at the output Q
are reversed (negated). At output Q of a Non-disjunction state H exists if state H is not
present on any of the inputs.

Status LEDs

Circuit diagram
Function block diagram

Switch

Button

Figure 1: Learning card 5 - Non-disjunction

Correlation list 1
Symbol absolute Comment
S1 I1 Switch
S2 I3 Switch
P1 Q1 Status LED

Correlation list 2
Symbol absolute Comment
S3 I5 Switch
S4 I6 Switch
P2 Q4 Status LED
Author: Jürgen Kaftan © 2010
2 Solution sheet: Non-disjunction with LOGO!Learn

Exercise with correlation list 1

❏ Enter the program according to function block diagram (FBD) into the programming
unit (PC) and transfer into the LOGO!.

❏ Test the circuit with the training device LOGO!Learn according to function table.

❏ Read-off the signal states at the Status LEDs of the training device LOGO!Learn and
enter them into the right column of the function table:

Function table
I1 I3 Q1
H H L
H L L
L H L
L L H

❏ Draw the function block diagram together with the respective parameters into the
solution field 1.
Solution field 1

Figure 2: Logic circuit for Non-disjunction (Function block diagram)

Author: Jürgen Kaftan © 2010


3 Solution sheet: Non-disjunction with LOGO!Learn

Exercise with correlation list 2

❏ Enter the program according to ladder diagram (LAD) into the programming unit
(PC) and transfer into the LOGO!.

❏ Test the circuit with the training device LOGO!Learn according to function table.

❏ Read-off the signal states at the Status LEDs of the training device LOGO!Learn and
enter them into the right column of the function table:

Function table
I5 I6 Q4
H H L
H L L
L H L
L L H

❏ Draw the ladder diagram together with the respective parameters into the solution
field 2.
Solution field 2

Figure 3: Logic circuit for Non-disjunction (Ladder diagram)

Author: Jürgen Kaftan © 2010

You might also like