Lower Body Strength Training Exercises
Lower Body Strength Training Exercises
Brought to you by the Department of Kinesiology and Health at Georgia State University.
Squat
Prime Movers/Muscle worked: Quadriceps (the muscles on the front of the upper leg), Hamstrings ( the muscles
on the back of the upper leg), Gluteals, Hip Flexors, and Calf muscles.
Beginning Position:
Begin by placing the straight bar on the rack just below shoulder level
Once the proper weights have been added, be sure to put a collar on each side of the bar to hold weights in place
Step under the bar, making sure it rests on the area just below the base of your neck and between the shoulders
(find the most comfortable spot)
Place your hands around the bar on either side of your shoulders in a position that feels comfortable to you
Place one foot in front of your upper body and one behind before lifting the bar of of the rack
Once the bar has been removed, position your feet so they are shoulder-width apart
Toes should point in the same direction as your knees
The upper body should be straight and erect with head facing forward
Abdominals should be slightly contracted to assist in keeping the back straight
For added safety it is recommended that a securely fastened weight belt be worn around the waist (specifically
the low back) whenever squatting exercises are performed.
Make sure to look forward and inhale during the entire movement
Keeping both feet firmly on the floor begin lowering your body while bending at the hips (3-4 count) and
forcing your buttocks out behind you
Immediately after initiating the bend at the hips begin bending at the knees to lower your body toward the
ground
Make sure your knees do not pass over the front of your toes, if this occurs add more bending at the hip (It
should look similar to a sitting movement)
Concentrate on keeping your back perfectly straight and not leaning forward
Lower your body until your upper leg becomes parallel to the floor
Return to the downward movement phase instructions and repeat the same movement.
Lunge
Prime Movers/Muscles Worked: Quadriceps (the muscles on the front of the upper leg), Hamstrings ( the
muscles on the back of the upper leg), Gluteals, Hip Flexors, and Calf muscles.
Machine: None Required, Can be done with body weight or hand-held weights
Beginning Position:
With the right foot take a large step forward while keeping the left foot in place
The right foot should be placed far enough forward that the knee does not pass over the front of the foot during
this exercise
Once the right foot is firmly on the floor lower the upper body by bending at the right knee (3-4 count) until the
Push with the right foot into the floor in an upward and backward direction (3-4 count) in order to raise the body
into an erect posture
Be careful to maintain a smooth, controlled movement while returning to the starting position to avoid losing
your balance
You are now in the beginning phase and can repeat the movement with the left foot forward
Leg Extension
Prime Movers/Muscle worked: Quadriceps (the muscles on the front of the upper leg)
Beginning Position:
Lift the legs/feet so that they are straight out in front of you
Lift weight slowly and under control (3-4 count)
Maintain proper alignment with back supported during all phases
Remain seated throughout exercise
Exhale while lifting or at the sticking point
Lower weight slowly (3-4 count) and under control to starting position without allowing the weight stack to rest
Remain seated and continue to have back supported
Leg Curl
Prime Movers/Muscles worked: Hamstrings (the muscles on the back of the upper leg)
Machine: Leg curl (hamstring curl) Leg curl machines can be supine (lying on your stomach to do the exercise) or
upright (seated with back supported) depending on the equipment available. Both are described below.
SUPINE MACHINE
Beginning Position:
Beginning Position:
Hip Abduction
Prime Movers/Muscles worked: gluteus medius
Beginning Position:
Adjust the lever on the side of the machine so that the movement arms are together
Select the proper resistance/weight
Sit on the seat and keep the back supported the back bench
Place the legs against the thigh pad
Lightly grasp the handles located on the side of the machine
Press the legs outward against the thigh pad so that the legs are as far apart as possible
Once the legs have reached their maximal point, allow the weight to return to the starting position under control
Hip Adduction
Prime Movers/Muscles worked: inner thigh (hip adductors)
Beginning Position:
Adjust the lever on the side of the machine so that the movement arms are as far as possible with the legs on the
movement arms
Place legs against the thigh pads with the inner thigh against the pads
Bring the legs together as close as possible by pushing the legs together
Calf Raise
Prime Movers/Muscles Worked: Gastrocnemius (calf muscle), Soleus (under the calf muscle)
Machine: Seated Calf Raise or Upright Calf Raise with Body Weight
Beginning Position:
Lower the weight (3-4 count) by dropping the heels as low as possible and keeping the ball of the foot in
constant contact with the platform
Push with the ball of the foot into the platform and lift the heels as high as possible (3-4 count)
Repeat the movement in a smooth, controlled motion
Beginning Position:
Stand erect with ball of foot positioned on a stable elevated surface (stair or ledge)
Keep the body straight and lower the heels (3-4 count) as far down as possible while keeping the balls of the
foot in contact with the ground
Repeat the movement in a smooth, controlled motion without rocking the body forward and backward
The Exercise and Physical Fitness Web Page is an ongoing project by graduate students in the Master of Science
program in Exercise Science in the Department of Kinesiology and Health at Georgia State University. This project
was created by J. Andrew Doyle, PhD, and was last modified on: August 01, 1997.