Scribd
Upload
50 views2 pages

Calculation Title: Data Set:: Beam Properties

This document contains an analysis of a waler beam with the following key details: - The 1100mm long beam has knife-edge supports at 250mm and 850mm. - It is subjected to a uniform distributed load of 6.5kN/m along its length. - Graphical outputs show the bending moment, shear force and deflection diagrams, with the maximum and minimum values reported.

Uploaded by

Mohammed Hafiz
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
50 views2 pages

Calculation Title: Data Set:: Beam Properties

This document contains an analysis of a waler beam with the following key details: - The 1100mm long beam has knife-edge supports at 250mm and 850mm. - It is subjected to a uniform distributed load of 6.5kN/m along its length. - Graphical outputs show the bending moment, shear force and deflection diagrams, with the maximum and minimum values reported.

Uploaded by

Mohammed Hafiz
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Job Number Drawing Sheet of Rev.

Customer ................................................................................................... 09-07-2021


Date ..............................

Project ....................................................................................................... By ..................................

Structure .................................................................................................... Approved .......................

Calculation Title : Waler analysis


Data Set : (Note : all positions are measured in millimetres from the left-hand end of the beam)
Beam Properties : Section Type : User Defined
Bending Stiffness, EI : 25.16 kNm²
Shear Stiffness, GA : Not Included
Self Weight, w : 0.010 kN/m (not included automatically in loading)
Overall Length, L : 1100 mm
Supports : Support No. Position (mm) Support Type Spring Stiffness (kN/mm)
1 250 Knife-Edge -
2 850 Knife-Edge -
Distributed Loads : Load No. Position (mm) Intensity (kN/m) Load Type
0 0 - 1100 6.5 - 6.5 Uniform

Point Values : (No Point Values Stored)

By the use of this Software you agree to the RMD Kwikform Terms and Conditions of Use and associated
limitations of liability detailed on the RMD Kwikform branded CD Sleeve issued with the original Software. Page 1
Job Number Drawing Sheet of Rev.

Customer ................................................................................................... 09-07-2021


Date ..............................

Project ....................................................................................................... By ..................................

Structure .................................................................................................... Approved .......................

Graphical Output : Waler analysis


0.0 0.5 1.0 metres

6.5 kN/m 6.5 kN/m

3.6 kN 3.6 kN

Bending Moment Diagram (kNm) Largest Positive Value = +0.089 kNm, Largest Negative Value = -0.203 kNm

-0.203 -0.203

0.000 0.000

Shear Force Diagram (kN) Largest Positive Value = +1.94 kN, Largest Negative Value = -1.94 kN

-1.94
-1.63

0.00 0.00

+1.63
+1.94

Deflection Diagram (mm) Largest Positive Value = +0.2 mm, Largest Negative Value = 0.0 mm

+0.2 +0.2

By the use of this Software you agree to the RMD Kwikform Terms and Conditions of Use and associated
limitations of liability detailed on the RMD Kwikform branded CD Sleeve issued with the original Software. Page 2

You might also like