Scribd
Upload
15K views3 pages

Fault Code 5655: Aftertreatment 1 SCR Conversion Efficiency - Condition Exists

Uploaded by

panchoreyes1
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
15K views3 pages

Fault Code 5655: Aftertreatment 1 SCR Conversion Efficiency - Condition Exists

Uploaded by

panchoreyes1
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

File: 189-fc5655 Page 1 of 3

Fault Code 5655

Aftertreatment 1 SCR Conversion Efficiency - Condition Exists

CODES REASON EFFECT

Fault Code: 5655 NOx conversion across the SCR Possible reduced engine performance.
PID(P), SID(S): catalyst is too low.
SPN: 4364
FMI: 11/31
Lamp: Amber
SRT:

Engine Control Module (ECM)

Circuit Description:
The engine control module (ECM) monitors the NOx concentration in the engine's exhaust gases using an
aftertreatment intake NOx sensor and an aftertreatment outlet NOx sensor. By comparing these two values, the ECM
is able to determine the conversion efficiency of the SCR catalyst and dosing system.

Component Location:
The SCR catalyst is located in the vehicle's exhaust system, after the diesel particulate filter and decomposition tube.

Conditions for Running the Diagnostics:


This diagnostic has to meet specific engine and aftertreatment conditions to run and complete.

Conditions for Setting the Fault Codes:


The Engine Control Module (ECM) detected the NOx conversion across the SCR catalyst was less than expected.

Action Taken When the Fault Code is Active:


• The ECM illuminates the amber CHECK ENGINE lamp and/or the malfunction indicator lamp (MIL) immediately
when the diagnostic runs and fails.
Engine torque will be reduced if the engine is operated for an extended period of time with this fault active.

© 2008 Cummins Inc., Box 3005, Columbus, IN 47202-3005 U.S.A. Printed from QuickServe® Online.
All Rights Reserved. Last Modified: 25-May-2019
File: 189-fc5655 Page 2 of 3
Conditions for Clearing the Fault Code:
• It is necessary to use the "Reset All Faults" command in the recommended Cummins electronic service tool or
equivalent to clear this fault and extinguish the amber CHECK ENGINE lamp and/or Malfunction Indicator Lamp
(MIL).

Shop Talk:
Troubleshoot all other active NOx sensor and SCR dosing system related fault codes before this fault.
Possible causes of this fault code include:
Malfunctioning aftertreatment diesel exhaust fluid dosing system.
Exhaust system leaks
Malfunctioning SCR catalyst
Degraded, diluted, or incorrect diesel exhaust fluid
Diesel exhaust fluid deposits in the decomposition tube.
For unit that has come back into with repeat failures consider the possibility that customer is not using Ultra-low sulfur
Diesel fuel

Refer to Troubleshooting Fault Code 5655.

© 2008 Cummins Inc., Box 3005, Columbus, IN 47202-3005 U.S.A. Printed from QuickServe® Online.
All Rights Reserved. Last Modified: 25-May-2019
File: 189-fc5655 Page 3 of 3

© 2008 Cummins Inc., Box 3005, Columbus, IN 47202-3005 U.S.A. Printed from QuickServe® Online.
All Rights Reserved. Last Modified: 25-May-2019

You might also like