0% found this document useful (0 votes)
72 views

Manufacturing Operator Instructions

This document contains a test for the discipline of Manufacturing Operator. It consists of 79 multiple choice questions across various topics related to manufacturing, science, mathematics, and general knowledge. The test instructions specify that candidates should attempt all questions within a 90 minute time limit and circle the correct answer for each multiple choice question.

Uploaded by

Abdul Kabeer
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as RTF, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
72 views

Manufacturing Operator Instructions

This document contains a test for the discipline of Manufacturing Operator. It consists of 79 multiple choice questions across various topics related to manufacturing, science, mathematics, and general knowledge. The test instructions specify that candidates should attempt all questions within a 90 minute time limit and circle the correct answer for each multiple choice question.

Uploaded by

Abdul Kabeer
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as RTF, PDF, TXT or read online on Scribd
You are on page 1/ 13

Name __________________________________

Father Name __________________________________

Discipline Applied For Manufacturing Operator

Instructions:
1Attempt all questions, all questions carry equal marks
2Maximum time allowed is 90 minutes
3Multiple choice questions & encircle the correct answer

1. What causes Cavitation’s in centrifugal pump?

a. High suction pressure


b. Low suction pressure
c. High suction velocity

2. Venturimeter and orifice measure the ______ of the fluid.

a. Pressure
b. Maximum velocity
c. Average velocity

3. A perfect gas

a. Doesn’t satisfy PV=nRT


b. Incompressible and has zero viscosity
c. Has constant specific heat

4. Boundary layer exists in flow

a. Real fluids
b. Over flat surfaces only
c. Pipes only

5. The pressure at a point in a fluid is not the same in all direction when the fluid is
viscous and

a. Moving
b. Static
c. Cold

6. In an incompressible flow of fluids, the fluid


a. Temperature remains constant
b. Compressibility is greater than zero
c. Density does not change with pressure &temperature

7. Center of pressure in an immersed body is _________ the center of gravity

a. Above
b. Below
c. At

8. A relief valve

a. Provides backpressure for a cylinder


b. Unloads a pump
c. Is a directional control valve?

9. Cavitation in a centrifugal pump can be avoided by keeping the

a. Inlet pressure high


b. Out let pressure low
c. Inlet pressure low

10. The fluid property due to which mercury does not wet the glass is

a. Surface tension
b. Viscosity
c. Cohesion

11. With increase in temperature of pure water its

a. POH decreases and Ph increases


b. POH and pH both decreases
c. PH and POH both increases

12. Which of the following gas is most soluble in water

a. NH3
b. CO2
c. CH4

13. Vapour pressure of water at 100°C is about bar

a. 0.1013
b. 10.13
c. 1.013
14. Elements in a periodic table are arranged in order of their

a. Atomic number
b. Mass number
c. Atomic weight

15. Mass number of an atom is the sum of the numbers of

a. Neutrons and protons


b. Protons and electrons
c. Both a, b

16. A solution with reasonably permanent pH is called a

a. Ideal
b. Colloidal
c. Buffer

17. In _______ process ions of salts react with water to produce acidity or alkalinity.

a. Hydration
b. Hydrolysis
c. Electrolysis

18. Heat of transition is the heat evolved or absorbed when a substance is converted
from

a. Vapour to liquid
b. Solid to liquid
c. One allotropic form to another allotropic form

19. NaOH contains ________ percent oxygen

a.10
b.16
c.40

20. Moisture can be removed from lubricating oil using

a. Tubular centrifuge
b. Clarifier
c. Vacuum leaf filter

21. To remove dirt from flowing fluid we use a

a. Coagulant
b. Strainer
c. Gravity settler

22. Cyclones are used primarily for separating

a. Solids
b. Solids from fluids
c. Liquids

23. Epoxy resin is a

a. Good adhesive
b. Elastomer
c. Polyester

24. Ultra centrifuges are used for the separation of ________ solid particles

a. Coarse
b. Fine
c. Colloidal

25. Cellulose content of bamboo and ideal fibrous raw material for the manufacture
of paper is 50%.

a. True
b. False

26. Propellers are radial flow mixers.

a. True
b. False

27. Pressure drop in fluidized bed reactor is more than that in a similar
Packed bed reactor.

a. True
b. False

28. A back mix reactor is same as ideal stirred tank reactor.

a. False
b. True

29. The converting of water into ice is a unit process.

a. True
b. False

30. First law of thermodynamics is dq=de+dw.

a. True
b. False

31. For an isothermal process the internal energy of a gas remains unchanged.

a. True
b. False

32. In an adiabatic process heat transfer is maximum.

a. True
b. False

33. Absorption is the separation technique used for desalination of seawater.

a. True
b. False

34. When the temperature and humidity of air is low we usually use natural draft
cooling tower.

a. True
b. False

35. At constant temperature, the thermal conductivities of gas decrease with the rise
in pressure.

a. True
b. False

36. An ejector is used to increase pressure.

a. True
b. False

37. The steam ejector is used to superheat the steam.

a. True
b. False

38. Maximum heat transfer rate is obtained in turbulent flow.

a. True
b. False

39. Urea is a possaic fertilizer.

a. True
b. False

40. The general formula of alkane family is CnH2n-2.

a. True
b. False

41. A centrifugal pump pumps crude oil.

a. True
b. False

42. Solvay process is used for the commercial production of nitric acid by the
catalytic oxidation of ammonia.

a. True
b. False

43. Catalyst used during the manufacturing of banaspati Ghee is zinc.

a. True
b. False

44. The most commonly used substance to speed up the sedimentation of sewage is
lime.

a. True
b. False

45. The bio chemical treatment applied to sewage effluent is a process of


polymerization.

a. True
b. False

46. Permanent hardness of water can be removed by passing it through cation and
anion exchanger.

a. True
b. False
47. Oils and fats are converted to soap in a process called saponification.

a. True
b. False

48. The combustion reaction C+O2 =CO2 is an endothermic reaction.

a. True
b. False

49. Bleaching of papers pulp is done with chlorine or chlorine dioxide.

a. True
b. False

50. Soap removes dirt by supplying hydrophilic group.

a. True
b. False

51. For maximum horizontal range, the angle of projection must be

a. 70
b. 45
c. 90

52. If a gunman standing in a stationary boat in water fires the gun in a horizontal
direction

a. The boat will spin around


b. The boat will move in the direction of target
c. The boat will move away from the target

53 The color of sky is blue because

a. Blue color has greater penetrating power


b. Blue color has least absorptive power
c. Blue color is scattered the most in the upper layers of atmosphere

54. Semi conductor is one, which has

a. Very large conductivity


b. Zero conductivity
c. Very small conductivity
55. When a radioactive nucleus emits a beta particles the proton neutron ratio

a. Remain same
b. Increase
c. Decrease

56. According to Einstein, when the velocity of a particle continuously increase, the
mass of the particle

a. Increase
b. Decrease
c. Increase for some time and then decrease

57. Photoelectric deals with the conversion of

a. Heat into light


b. Light into electricity
c. Electricity into light

58. Color television sets and microwave cooking ovens emits

a. Alpha rays
b. Beta rays
c. X rays

59. The direction of the magnetic field in an electromagnetic wave is

a. Parallel to the electrical field


b. Perpendicular to the electrical field
c. Parallel to the direction of propagation

60. In a moving coil galvano meter the deflecting couple depends upon

a. Value of magnetic field


b. Area of the coil
c. Number of turns in the coil

61. The job cannot be finished _______every one cooperates.

a. Meanwhile
b. Unless
c. As

62. The additive inverse of (-1,4) is

a. (1,4)
b. (-1, -4)
c. (1, -4)

63. The temperature of normal human body is 98.6°F this temperature corresponds
to

a. 30°C
b. 37°C
c. 40°C

64. The amount of energy needed to eject an electron from metal surface is called

a. Heat energy
b. Work function
c. Threshold frequency

65. The pentagon has _____ sides.

a. 7
b. 6
c. 5

66. An electric train is going from east to west its smoke will flow

a. West to east
b. Towards sky
c. None of them

67. When any solid is changed to gas without melting the process is called

a. Diffusion
b. Sublimation
c. Distillation

68. How many words can be formed out of the letters of the word “FOCUS”?

a. 120
b. 720
c. 60

69. The general term of the following sequence is 1/3, 1/9, 1/27

a. 1/(n+2)
b. 1/n2
c. 1/3n

70. The apprentice found himself working for______ master, who would forgive not
mistake

a. Tight
b. Stern
c. Polite

71. Lethargic means:

a. Leather goods
b. Creamy
c. Lazy

72. PSO stands for

a. Pakistan star oil


b. Pakistan super oil
c. Pakistan state oil

73. Multitude means:

a. To increase in numbers
b. A great number of people
c. Multiply by

74. The national language of IRAN is:

a. Persian
b. Arabic
c. Forensic

75. Afghanistan secret service called:

a. Raw
b. Khad
c. Mosad

76. Alexandria is a seaport of

a. Greece
b. Libya
c. Egypt

77. The first bank opened in Pakistan was

a. U.B.L
b. H.B.L
c. N.B.L
78. Alexander Graham Bell is the inventor of telephone belonged to

a. Germany
b. U.S.A
c. England

79. The biggest airport in the word at Dallas is situated in

a. Germany
b. U.S.A
c. France

80. Name the hottest place in Pakistan

a. Jacobabad
b. Multan
c. Sibi

81. Who did write the national anthem of Pakistan?

a. Ch.Rehmat Ali
b. Hafeez jahlandhari
c. Sir Syed Ahmed Khan

82. Follow –on is a term used in the game of

a. Badminton
b. Baseball
c. Cricket

83. Anatoly Karpov, the world chess champion belongs to

a. England
b. Russia.
c. U.S.A

84. The height of cricket stumps out of ground is

a. 28 inches
b. 26 inches
c. 35 inches

85. First cricket world cup was played in:

a. 1971
b. 1973
c. 1975

86. First country that recognized Pakistan as an independent country was

a. Saudi Arabia
b. Iran
c. Afghanistan

87. Which is the key industry of Pakistan

a. Cement
b. Petrochemical
c. Agriculture

88. The biggest center of textile is

a. Faisalabad
b. Gujranwala
c. Lahore

89. The first referendum in Pakistan took place in

a. 1982
b. 1977
c. 1984

90. Pulmonary arteries carry

a. Oxygenated blood
b. Deoxygenate blood
c. White blood

91. Coal, oil, gas are collectively known as

a. Fossil fuels
b. Mineral fuels
c. Prehistoric fuels

92. Sulphuric acid mist when inhaled can damage:

a. Heart
b. Lungs
c. Liver

93. A haemoglobin molecule consists of number of atoms

a.9125
b.9512
c.9152

94. The endocrine glands produce chemicals known as

a. Enzymes
b. Catalyst
c. Hormones
95. The process of splitting of atom is known as
a. Cracking
b. Fission
c. Splition
96. Wilkins and Franklin made x-ray studies of crystals of:
a. DNA
b. RNA
c. ADP

97. The product of photosynthesis are molecular oxygen, water and

a. Alcohol
b. Sodium chloride
c. Glucose

98. Pasteurization is possible at°62

a. 15 minutes
b. 32minutes
c. 40minutes

99. Soon after fertilization zygote starts undergoing

a. Gastrulation
b. Growth
c. Cleavage

100. Wood is largely made of:

a. Starch
b. Cellulose
c. Glycerin

You might also like