Scribd
Upload
45 views1 page

Wood-Based Panels: Determination of Modulus of Elasticity in Bending and of Bending Strength

Uploaded by

Ahmed Khameis
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
45 views1 page

Wood-Based Panels: Determination of Modulus of Elasticity in Bending and of Bending Strength

Uploaded by

Ahmed Khameis
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

EN 310: 1993

Wood-based panels: Determination of modulus of elasticity in bending and of bending


strength

This specifies a method of determining the apparent modulus of elasticity in flatwise


bending and bending strength of wood-based panels of nominal thickness ≥ 3mm.

The modulus of elasticity in bending and bending strength is determined by applying


a load to the center of a test piece supported at two points.  The modulus of
elasticity is calculated by using the slope of the linear region of the load-deflection
curve.  The value calculated is the apparent modulus, not the true modulus,
because the test method includes shear as well as bending.  The bending strength
of each test piece is calculated by determining the ratio of the bending moment M, at
the maximum load Fmax, to the moment of its full cross section.
 This should not to be used for structural design.
 For structural design values, refer to EN 789 – Timber structures – Test method –
determination of mechanical properties of wood-based panels.

You might also like