Scribd
Upload
14 views1 page

5.5.2 Start: Commissioning 5.5 Start-Up With The Operator Panel and The Ready-For-Use Software

The document discusses starting up a TP700 Comfort Panel connected directly to a WP521/WP522 weighing module. It describes selecting the quick start function from the main menu to be guided through setting important parameters. All parameter inputs must be saved by clicking the diskette icon.

Uploaded by

Cristi Crse
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
14 views1 page

5.5.2 Start: Commissioning 5.5 Start-Up With The Operator Panel and The Ready-For-Use Software

The document discusses starting up a TP700 Comfort Panel connected directly to a WP521/WP522 weighing module. It describes selecting the quick start function from the main menu to be guided through setting important parameters. All parameter inputs must be saved by clicking the diskette icon.

Uploaded by

Cristi Crse
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Commissioning

5.5 Start-up with the operator panel and the Ready-for-use software

5.5.2 Start
The quick start is performed in this example with a TP700 Comfort Panel connected directly
to the WP521/WP522. The panel communicates directly via Modbus TCP/IP or via the
SIMATIC S7-1500 CPU.
To carry out the quick start, select the "1.0 Setup" function in the main menu and then "1.2
Quick Start". You will be guided through the individual tasks for setting the most important
parameters.
The remaining parameters are factory-set in such a way that they can be used in most cases
without any changes.
All parameter inputs must be saved by clicking on the diskette icon.

Image 5-3 Quick Start 1 of 6

SIWAREX WP521/WP522
Manual, 04/2016, A5E36695225A 39

You might also like