Scribd
Upload
437 views

GoodWe Modbus TCP - IP Communication Solution

This document provides information about GoodWe inverters' MODBUS RTU and TCP/IP communication protocols. It outlines that MODBUS TCP/IP compatibility requires an ARM firmware version 13 or higher and a LAN module instead of a Wi-Fi module. The document includes wiring diagrams and configuration instructions for MODBUS TCP/IP communication, noting the IP addresses must be on the same network segment and the server port should be set to 502.

Uploaded by

Josimar Silva
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
437 views

GoodWe Modbus TCP - IP Communication Solution

This document provides information about GoodWe inverters' MODBUS RTU and TCP/IP communication protocols. It outlines that MODBUS TCP/IP compatibility requires an ARM firmware version 13 or higher and a LAN module instead of a Wi-Fi module. The document includes wiring diagrams and configuration instructions for MODBUS TCP/IP communication, noting the IP addresses must be on the same network segment and the server port should be set to 502.

Uploaded by

Josimar Silva
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

GoodWe Modbus

TCP/IP Communication Solution VER 02, UPDATED ON APR 26, 2021

GoodWe provides a communication protocol on storage inverters through MODBUS RTU or TCP/IP, which is a communication
solution with third party devices.

Compatibility Map:

MODBUS RTU MODBUS TCP/IP


Compatibility Firmware Compatibility Firmware
ES/EM/SBP √ ARM 01 or higher × NA
EH/BH/ET/BT √ ARM 01 or higher √ ARM 13 or higher

Requirements of Using MODBUS TCP Protocol:

1. Firmware of ARM chip shall be 13 or higher version

2. Use LAN module instead of Wi-Fi module


Note: As the default communication method is by Wi-Fi,
LAN modules for MODBUS TCP communication shall be
purchased separately from GoodWe and take over Wi-Fi
module.

3. Please contact GoodWe sales to apply for the document


LAN Module

Wirings Diagrams for MODBUS TCP Communication

1. Direct connection to LAN module 2. Connect in the Ethernet network with inverter

Router 3rd Party Device


3rd Party Device

LAN Module
LAN Module

1
GoodWe Modbus
TCP/IP Communication Solution VER 02, UPDATED ON APR 26, 2021

Configuration

1 4

1. Set the connection to “Modbus TCP/IP”


2. Set the IP address,make sure the IP address
2 of the inverter and third-party device under the
same segment.
3 3. Set the server port to “502”
4. Click “OK”

Note:
1. For network connection, please follow the LAN Module Installation Manual of GoodWe.
2. This instruction could be updated without notice as the solution could be modified.

You might also like