electronics fundamentals

circuits, devices, and applications

PRESENTED BY: M. GXAMZA

chapter 5

Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle

Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Summary
Resistors in parallel

Resistors that are connected to the same two points

are said to be in parallel.

A
R1 R2 R3 R4

Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle

Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Summary
Parallel circuits

A parallel circuit is identified by the fact that it has

more than one current path (branch) connected to a
common voltage source.

+ R1 R2 R3 R4
VS

Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle

Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Summary
Parallel circuit rule for voltage
Because all components are connected across the same
voltage source, the voltage across each is the same.
For example, the source voltage is 5.0 V. What will a volt-
meter read if it is placed across each of the resistors?
+5.0 V +5.0 V +5.0 V +5.0 V
- + - + - + - +

VS R1 R2 R3
+5.0 V 680 Ω 1.5 kΩ 2.2 kΩ

Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle

Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Summary
Parallel circuit rule for resistance
The total resistance of resistors in parallel is
the reciprocal of the sum of the reciprocals of
the individual resistors.
For example, the resistors in a parallel circuit are 680 Ω,
1.5 kΩ, and 2.2 kΩ. What is the total resistance? 386 Ω

+ R1 R2 R3
VS
680 Ω 1.5 kΩ 2.2 kΩ

Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle

Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Summary
Special case for resistance R1 R2
of two parallel resistors

The resistance of two parallel resistors can be found by

1 R1 R2
either: RT = or RT =
1
+
1 R1 + R2
R1 R2

What is the total resistance if R1 = 27 kΩ and

R2 = 56 kΩ? 18.2 kΩ

Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle

Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Summary
Parallel circuit + R1 R2 R3
VS
680 Ω 1.5 kΩ 2.2 kΩ

Tabulating current, resistance, voltage and power is a

useful way to summarize parameters in a parallel circuit.
Continuing with the previous example, complete the
parameters listed in the Table.

I1= 7.4 mA R1= 0.68 kΩ V1= 5.0 V P1= 36.8 mW

I2= 3.3 mA R2= 1.50 kΩ V2= 5.0 V P2= 16.7 mW
I3= 2.3 mA R3= 2.20 kΩ V3= 5.0 V P3= 11.4 mW
IT= 13.0 mA RT= 386 Ω VS= 5.0 V PT= 64.8 mW
Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle
Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Summary
Kirchhoff’s current law

Kirchhoff’s current law (KCL) is generally stated as:

The sum of the currents entering a node is equal to the
sum of the currents leaving the node.
Notice in the previous example that the current from
the source is equal to the sum of the branch currents.

I1= 7.4 mA R1= 0.68 kΩ V1= 5.0 V P1= 36.8 mW

I2= 3.3 mA R2= 1.50 kΩ V2= 5.0 V P2= 16.7 mW
I3= 2.3 mA R3= 2.20 kΩ V3= 5.0 V P3= 11.4 mW
IT= 13.0 mA RT= 386 Ω VS= 5.0 V PT= 64.8 mW
Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle
Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Summary

Current divider
When current enters a node (junction) it divides into
currents with values that are inversely proportional to the
resistance values.
The most widely used formula for the current divider
is the two-resistor equation. For resistors R1 and R2,
 R2   R1 
I1 =   I T and I 2 =   IT
 R1 + R2   R1 + R2 
Notice the subscripts. The resistor in the numerator is
not the same as the one for which current is found.
Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle
Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Summary

Current divider
Assume that R1is a 2.2 kΩ resistor that is in
parallel with R2, which is 4.7 kΩ. If the total
current into the resistors is 8.0 mA, what is
the current in each resistor?
 R2   4.7 kΩ 
=I1 =  IT   8.0 mA = 5.45 mA
 R1 + R2   6.9 kΩ 
 R1   2.2 kΩ 
=I 2 =  T 
I  8.0 mA = 2.55 mA
 R1 + R2   6.9 kΩ 
Notice that the larger resistor has the smaller current.
Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle
Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Summary

Power in parallel circuits

Power in each resistor can be calculated with any of the
standard power formulas. Most of the time, the voltage is
V2
known, so the equation P = is most convenient.
R
As in the series case, the total power is the sum
of the powers dissipated in each resistor.

What is the total power if 10 V is applied to the parallel

combination of R1 = 270 Ω and R2 = 150 Ω? 1.04 W

Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle

Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Summary

Assume there are 8 resistive wires that form a rear window defroster
for an automobile.
(a) If the defroster dissipates 90 W when connected to a 12.6 V source,
what power is dissipated by each resistive wire?
(b) What is the total resistance of the defroster?
(a) Each of the 8 wires will dissipate 1/8 of the total
power or 90 W
= 11.25 W
8 wires
(12.6 V )
2
V2
(b) The total resistance is =R = = 1.76 Ω
P 90 W

What is the resistance of each wire? 1.76 Ω x 8 = 14.1 Ω

Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle

Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Key Terms
Parallel The relationship in electric circuits in which
two or more current paths are connected
between two separate points (nodes).
Branch One current path in a parallel circuit.

Kirchhoff’s A law stating the total current into a node

current law equals the total current out of the node.

Node A point or junction in a circuit at which two

or more components are connected.
Current divider A parallel circuit in which the currents divide
inversely proportional to the parallel branch
resistances.
Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle
Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Quiz

1. The total resistance of parallel resistors is equal to

a. the sum of the resistances
b. the sum of the reciprocals of the resistances
c. the sum of the conductances
d. none of the above

Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle

Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Quiz

2. The number of nodes in a parallel circuit is

a. one
b. two
c. three
d. any number

Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle

Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Quiz

3. The total resistance of the parallel resistors is

a. 2.52 kΩ
b. 3.35 kΩ
R1 R2 R3
c. 5.1 kΩ 10 kΩ 10 kΩ 5.1 kΩ

d. 25.1 kΩ

Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle

Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Quiz

4. If three equal resistors are in parallel, the total

resistance is
a. one third the value of one resistor.
b. the same as one resistor.
c. three times the value of one resistor.
d. the product of the three resistors

Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle

Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Quiz

5. In any circuit the total current entering a node is

a. less than the total current leaving the node.
b. equal to the total current leaving the node.
c. greater than the total current leaving the node.
d. can be any of the above, depending on the circuit.

Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle

Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Quiz

6. The current divider formula to find I1 for the special

case of two resistors is
 R1 
a. I1 =   IT
 RT 
 R2 
I =
b. 1   IT
 RT 
 R2 
c. I1 =   IT
 R1 + R2 
 R1 
d. I1 =   IT
 R1 + R2 

Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle

Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Quiz

7. The total current leaving the source is

a. 1.0 mA
b. 1.2 mA VS + R1 R2
12 V 10 kΩ 2.0 kΩ
c. 6.0 mA
d. 7.2 mA

Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle

Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Quiz

8. The current in R1 is
a. 6.7 mA
b. 13.3 mA R1 R2
I = 20 mA 100 Ω 200 Ω
c. 20 mA
d. 26.7 mA

Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle

Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Quiz

9. The voltage across R2 is

a. 0 V
b. 0.67 V R1 R2
I = 20 mA 100 Ω 200 Ω
c. 1.33 V
d. 4.0 V

Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle

Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Quiz

10. The total power dissipated in a parallel circuit is

equal to the
a. power in the largest resistor.
b. power in the smallest resistor.
c. average of the power in all resistors.
d. sum of the power in all resistors.

Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle

Floyd/Buchla River, NJ 07458. All Rights Reserved.
Chapter 5
Quiz

Answers:
1. d 6. c
2. b 7. d
3. a 8. b
4. a 9. c
5. b 10. d

Electronics Fundamentals 8th edition © 2010 Pearson Education, Upper Saddle

Floyd/Buchla River, NJ 07458. All Rights Reserved.