0% found this document useful (0 votes)
21 views3 pages

GSM Status

This document describes a GSM 6 relay controller that allows remote control of devices using a cell phone from anywhere in the world. It has 6 independent relay switches that can be programmed to turn on and off using SMS text messages. The relay controller connects to the cellular network and has its own phone number, allowing control without incurring call costs.

Uploaded by

rajesshkm
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
21 views3 pages

GSM Status

This document describes a GSM 6 relay controller that allows remote control of devices using a cell phone from anywhere in the world. It has 6 independent relay switches that can be programmed to turn on and off using SMS text messages. The relay controller connects to the cellular network and has its own phone number, allowing control without incurring call costs.

Uploaded by

rajesshkm
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

GSM 6 RELAY CONTROLLER

Remote control using a cell phone from anywhere in the world!

1. The GSM-AUTO is a GSM remote control switch, it connects to the cell phone
network and like a cell phone has its own cell phone number.
2. The GSM-AUTO is activated by Sending SMS to its cell phone number, it will
recognize an authorized telephone number calling
3. It rejects the call without answering and switch on or off the device connected to it,
because it rejects the call without answering there are no call costs incurred
4. It has 6 independent relay switches with normally open and normally closed switch
contacts, these can be programmed to switch ON by Sending SMS #A1 #B1 #C1
#D1 #E1 #F1.
5. The relay switches can also be switched OFF by sending SMS #A0 #B0 #C0 #D0
#E0 #F0
6. GSM Module will give the reply the relay status by sending back a text message.
7. You can check the relay status by sending the STS command

Product Highlight:

1. Dual band-based GSM Modem 2G,3G, 4G SIM card will work


2. Independent relays that can be programmed to switch on and OFF Using SMS.
3. Two access modes are available, open access where the GSM-AUTO will respond to
any incoming call, and secure access where it will only respond to programmed
authorized telephone numbers.
4. The relays can be temporarily switched on and Off by sending the GSM-AUTO a text
message command, a confirmation text will be returned when the relays turn ON and
OFF if required.
5. 6 relays with normally open (N.O) and normally closed (N.C) contacts, maximum
switching capacity is 10 amps @ 230V ac per relay.
6. For more current you can add the contactor and draw any Amps load

Specification:

1. Operating Voltage - 12VAC/ DC Min 2 Amps


2. Can Accept SIM card of any GSM Mobile operator (2G, 3,4G)
3. Each Relay 10 amps capacity

FEBO Solution
Flat No T1 , Shiva Heritage
Bangalore- 560062 PH: 7795553275
GSM 6 RELAY CONTROLLER

SIMPLE COMMANDS FOR OPERATING THE MODULE

command Function Example


#X To store 1st No
2STN9999999999 To store 2nd
#1STNXXXXXXXXXX To store no’s from 1-10
No
#STS To check Status
#RESET Load Factory Defaults
#info to check version
#*xxx To check balance to check airtel SMS - #*123
#SPN To check stored No
#A1 - #F1 To switch on relays
#A0- #F0 To switch Off relay s
#L0 &L1 All relay On / Off
#ABCXXX Multi relay function SMS to on ABC - #ABC111
#DEFXXX Multi relay function

SMS To on Relay A for 40 sec -


#STx(A-F)=XX Timer in seconds
#STA=40
SMS To on Relay A for 10 min -
#MTx(A-F)=XX Timer in Minutes
#MTA=10
SMS To on Relay A for 1 Hour -
#HTx(A-F)=XX Timer in Hours
#HTA=1

HTL=T1T2 Sequence 1 Relay A B On for set Hours T1 1 TO 9 Hours


Relay B Off , Relay C on For set
Sequence 2 T2 1 TO 9 Hours
hours
Sequence 3 All ABC relays Go OFF

HTM=T1T2 Sequence 1 Relay C on Relay B off T1 1 TO 9 Hours


if Relay A is ON Relay B ON Relay
Sequence 2 T2 1 TO 9 Hours
A Off

FEBO Solution
Flat No T1 , Shiva Heritage
Bangalore- 560062 PH: 7795553275
GSM 6 RELAY CONTROLLER

FEBO Solution
Flat No T1 , Shiva Heritage
Bangalore- 560062 PH: 7795553275

You might also like