Scribd
Upload
71 views1 page

TD-9027-000-ENG - Splicing Kits

Splicing kits are used to connect anode cables to main cables or for buried cable connections. The kits contain molds and epoxy resin for making watertight connections between cable insulations. Users follow instructions to prepare the cable ends, insert them into the molds, pour epoxy resin, and allow it to cure to complete the connection. Splicing kits come in various configurations for different numbers of cable connections.

Uploaded by

Soltani Ali
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
71 views1 page

TD-9027-000-ENG - Splicing Kits

Splicing kits are used to connect anode cables to main cables or for buried cable connections. The kits contain molds and epoxy resin for making watertight connections between cable insulations. Users follow instructions to prepare the cable ends, insert them into the molds, pour epoxy resin, and allow it to cure to complete the connection. Splicing kits come in various configurations for different numbers of cable connections.

Uploaded by

Soltani Ali
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Splicing Kits

General
Splicing kits are used for anode/rinomain cable connections (derivations type) and for buried cable
connections (in-line type).
The connection between the anode cable and the main cable is made by roving cables insulation (the
main cable must not be interrupted) then fixed with a watertight brass. Once the connection is made,
it is insertedin the splicing kit and filled with epossidic resine (normally supplied with each splicing kit).
To proceed with the above operations, follow the below instructions.

Use instructions
STEP 1:
- Adapt mould end to cables O.D.
- Remove cables sheath and crimp conductors ends.
- Wrap bare crimped cables connection with adhesive tape.

STEP 2:
- Insert connected cables into the mould body.
- Clip mould halves toghether.
- Seal mould conical ends by wrapping them with adesive tape.
- Fit the funnels on the mould body.
STEP 3:
- Break center seam of resin compound container.
- Mix accurately content until resin achieves uniform colour.

STEP 4:
- Cut-off a resin container corner and pour the resin into a funnel
until both funnels are filled.
- Be sure that no air bubbles remain inside mould body.
- Close the funnels with attacched caps.

Same operation are valid for 3/4/5 ways derivations.

Main configurations
P-9028-000 – In-line type P-9027-001 – P-9027-000 – Three ways derivation
(unipolar cable section range 4-50sqmm) type
(unipolar cable section range 4-50sqmm/6 70sqmm)
www.telemagnetica.com

P-9027-003 – Four ways derivation type P-9027-002 – Five ways derivation type
(unipolar cable section range 10-50sqmm) (Unipolar cable section range 10-50sqmm)

March 2009 TD-9027-000-ENG-01 Pag. 1 of 1

You might also like