MITSUBISHI MGS SERIES

DIESEL GENERATOR SET

60Hz/1800 rpm/480V

MGS1400B
POWER RATING (0.8 P.F.) MODEL CODE
STAND-BY 1420 kW 6S-7PC
PRIME 1280 kW 6P-7PC

MGS1400B with typical options

Voltage Variation
■ Standard Voltage 3Phase 4 Wires
480V
■ Voltages Available 3Phase 4 Wires
480, 460, 450, 440 and 416V
Note: Outputs for optional voltages may differ from standard output mentioned above.

CONDITIONS & DEFINITIONS

Stand-by: Code: S
Applicable for supplying emergency power at varying load in the event of the normal utility power interruption.
Fuel stop power in accordance with ISO15550, ISO3046/1, JISB8002-1, DIN6271 and BS5514.
Overload: not allowed

Prime: Code: P
Applicable for supplying emergency power at varying load in the event of normal utility power interruption. 10% overload is
allowed.
Fuel stop power in accordance with ISO15550, ISO3046/1, JISB8002-1, DIN6271 and BS5514.
Overload: 10% allowed

Conditions:
Engine ratings are based on SAE J1349 standard conditions and also apply at ISO3046/1, DIN6271 & BS5514 standard
conditions.
Fuel rates: based on ASTM D975, BS2869 and on fuel oil of 35° API (16°C or 60° F) gravity having a LHV of 42,780 kJ/kg
(18,390 Btu/lb.) when used at 29°C (85° F) and weighing 838.9 g/liter (7.001lbs./U.S. gal.).

Note: * For conditions of prime power (P.R.P.) and additional rating requirements, please consult your nearest Mitsubishi
MGS dealer.

DIMENSION (Reference Data)

Overall dimensions L : Length mm 4595

W : Width mm 2160
H : Height mm 2700
Total Weight (Dry) kg 9600
Total Weight (Wet) kg 10300
MITSUBISHI MGS SERIES
DIESEL GENERATOR SET
MGS1400B

MGS SERIES DIESEL ENGINE: MITSUBISHI S12R-PTA2-S

V-12, 4 stroke-cycle water-cooled, turbocharged and aftercooled

ENGINE SPECIFICATIONS & TECHNICAL DATA

Bore mm 170
Stroke mm 180
Displacement L 49
Piston speed m/sec. 10.8
Compression ratio 13.5
Lubricating oil capacity L 180
Coolant capacity without radiator L 125
Coolant pump external resistance m water 5.0
Coolant pump flow rate L/min 1850
Cooling fan airflow rate m3/min 2040
Cooling fan air flow restriction kPa 0.1
Ambient air temperature ℃ 40
Allowable exhaust back pressure kPa 6.0
Exhaust flange size (internal diameter) mm 300

ENGINE OPERATING DATA

STAND-BY PRIME
1420 kW 1280 kW
Gross Engine Power* kWm 1494 1353
Brake mean effective pressure MPa 2.1 1.9
Regenerative absorption kW 144 144
Noise Level at 1 m dB(A) 111 110
(excluding: intake, exhaust & fan)
Fuel consumption load 100%* L/hr. 394 350
Fuel consumption load 75%* L/hr. 294 267
Combustion air inlet flow rate m3/min 135 120
Exhaust gas flow rate m3/min 356 316
Exhaust gas temperature ℃ 530 520
Heat rejection to coolant kW 981 872
Heat rejection to exhaust kW 1282 1114
Heat rejection to atmosphere from engine kW 118 105
Heat rejection to atmosphere from generator kW 75 66
* WITH FAN basis.

Deration for engine

Note: Please consult with your nearest Mitsubishi MGS dealer

ENGINE STANDARD EQUIPMENT

Aftercooler
Turbocharger filter
Structure steel base
Crankcase breather
Charging alternator
Lubricating oil cooler
Fuel filters, full flow paper element
Fuel transfer pump, gear driven, plunger type
Electronic type governor
Jacket water heater
Jacket water pump, gear driven
Lubricating oil filter, full flow paper element
Lubricating oil pump, gear driven
Exhaust dry manifold
Radiator, blower fan, fan drive
Manual shutoff
24V DC electric starting motor
MITSUBISHI MGS SERIES
DIESEL GENERATOR SET
MGS1400B

MGS SERIES 7310 GENERATOR CONTROL PANEL

Type & Design
MGS standard 7310 programmable microprocessor control-automatic start/stop panel, generator breaker control,
indicating the operational status and fault conditions; automatically shutting down the engine and indicating the engine
failure by means of LCD display and LEDs on the front panel.

Controls & Monitoring

◆ Mode selection & start engine button with interlock key switch system
◆ Menu navigation button
◆ LCD display for: AC amperage-each phase and earth current, AC voltage-each phase and neutral, Frequency Hz,
Operation hours run, Lub. Oil pressure, Cooling water temperature, Generator Load kW/kVA/kVar, Generator Load
kWh/kVAh/kVarh
◆ Operation status LED indicators
◆ CB control buttons
◆ Mute/Lamp test button
◆ Voltage adjuster
◆ Speed adjuster
◆ Emergency stop pushbutton
◆ Provided 5 outputs for status as standard equipment (Programmable 8 outputs available as option)

Safety Shutdown Protection and LED Indicators

High engine temperature, Low oil pressure, Fail to start, Generator Over Speed/Frequency,
Generator Under Speed/Frequency
Generator High Voltage, Generator Low Voltage, Oil pressure sender circuit, Loss of Speed signal , Emergency stop,
High crankcase internal pressure (MGS-C continuous only)

Mounting
Fabricated cubicle mounted on individual bracket with anti-vibration isolator

Electrical Design
In accordance with BS EN 60950 Low Voltage Directive, BS EN 61006-2 and 61006-4 EMC Directive. The optional
interface can provide real time diagnostic facilities.

Generator Control Panel Description

■ 3 position operation mode control key switch
(ACTIVE, PANEL LOCK, STOP/RESET)
■ Manual button ■ Stop/Reset button (Manual only)
■ Auto button ■ Mute/Lamp test button (Manual only)
■ CB open button (Manual only) ■ Voltage adjusting trimmer
■ CB close button (Manual only) ■ Speed adjusting trimmer
■ Start engine button (Manual only) ■ Emergency stop pushbutton
■ LCD display accessed by scroll pushbutton
Generator volts L1-N, L2-N, L3-N Engine cooling water temperature (°C & °F)
Generator volts L1-L2, L2-L3, L3-L1 Battery volts
Generator amps L1, L2, L3 Engine hours run
Generator Earth Current Generator Load kW, kVA, kVar
Generator Frequency Hz Generator Load kWh, kVAh, kVarh
Engine speed RPM Power Factor
Engine oil pressure (PSI & Bar)
■ Visual indicators on LCD display
Shutdown alarm Generator high current
Warning alarm Over voltage (AC)
High coolant temperature Under voltage (AC)
Low oil pressure Over voltage (DC)
Charge fail Under voltage (DC)
Over-speed Auxiliary indication
Under-speed Auxiliary alarm (warning or shutdown)
Electrical trip Common alarm
Fail to stop Over frequency
Under frequency
■ Visual indication alarm and automatically shutdown
High engine temperature Over frequency
Low oil pressure Under frequency
Fail to start Oil pressure sender open circuit
Over-speed Loss of speed signal
High voltage High Crankcase internal pressure (MGS-C Continuous only)
Low voltage Emergency Stop
■ Operation status indicated by LED
Remote start present Lubrication oil filter clogged
Generator ready Electrical trip
■ Pre-Programmed Starting Unit
Automatic start/stop sequence timing and delay systems configured
via MS-Windows based software.
MITSUBISHI MGS SERIES
DIESEL GENERATOR SET
MGS1400B

MGS SERIES AC GENERATOR MODEL: MG-7PC

Type & Design
MGS original design, single bearing, 4 pole, screen protected, selfexciting, self regulating and brushless with fully
connected damper windings, salient pole rotors, A.C. exciter and rotating rectifier unit. Direct coupled to engine and
regreaseable bearing, direct drive centrifugal blower.
Enclosure: Drip-proof IP23
Winding System
Standard 6 wire winding provides 3 phase voltage. All windings are impregnated in vacuum pressure impregnated with a
special polyester resin.
Overspeed capability: 125% for 2 minutes
Insulation: Class 'H' of IEC
Temperature rise: Class 'H'
Voltage Regulator
Fully sealed, 3 phase RMS sensing AVR with built-in protection against sustained over-excitation. This de-excites the
generator after a minimum of 5 seconds.
Voltage regulation: Less than +/- 0.5% from no load to full load at any power factor between 0.8 lagging and 1.0
allowing for a 4% engine speed variation
Voltage adjustment: +/- 6%
Wave form: Less than 5% deviation
Permanent Magnet Generator (PMG)
Electrically isolated from the main alternator stator windings powers AVR - sustaining approx. 250～300% of short circuit
current at the AC generator output terminals for not more than 10 seconds by means of excitation voltage via AVR
Electrical Design
In accordance with BS5000 Part 3, VDE0530, UTE51100, NEMA MG1-22, CEMA, IEC34-1, CSA22.2, AS1359 and
JEC2100.
Telephone Influence Factor (TIF): Less than 50
Telephone Harmonic factor (THF): Less than 2%
Radio interference: Suppression is in line with the provision of BS800 and VDE Class G and N

Gen Set Option Features

■ ENGINE
Air Cleaner, paper element dry type
Battery Kit
Battery Charger
Anchor Bolts
■ FUEL
Fuel Day Service Tank
■ COOLING
Oversize radiator
Heat Exchanger
Expansion Tank
Removal STD Radiator, Fan & Fan Drive
■ LUBRICATION
Lub. Oil Priming Pump
■ EXHAUST
Exhaust Silencer
Exhaust Flexible Pipe
■ GENERATOR
Space Heater
3 phase Sensing Auto Voltage Regulator
Power Factor Regulator
■ CONTROL PANEL
Diesel Generator Integrated Communication Synthesizer (DGICS-MII)
Auxiliary Control Panel
Remote Monitor Interface
■ SWITCHGEAR
Circuit Breaker MCCB & ACB
Reverse Power Relay

Power Systems Engine Section, Engine Sales Department

16-5, KONAN 2-CHOME, MINATO-KU, TOKYO 108-8215 JAPAN
TEL: 81-3-6716-4771 FAX: 81-3-6716-5854
Mitsubishi Heavy Industries, Ltd. serves for the customers with improved products continually.
Therefore specification and some materials will be changed without notice.
The International System of units (SI) is used in this publication.