Scribd
Upload
39 views4 pages

Mechanical Engineering Department Technical Drawing in Engineering Universidad Carlos Iii de Madrid Escuela Politécnica Superior

Uploaded by

maria
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
39 views4 pages

Mechanical Engineering Department Technical Drawing in Engineering Universidad Carlos Iii de Madrid Escuela Politécnica Superior

Uploaded by

maria
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 4

UNIVERSIDAD Mechanical Engineering Department

CARLOS III DE MADRID BASICS OF ORTHOGRAPHIC PROJECTION


ESCUELA POLITÉCNICA SUPERIOR TECHNICAL DRAWING IN ENGINEERING

1. Draw the horizontal line s that goes through point A and is parallel to plane a. Point A, with height 25mm, belongs to a line r which is
in the first bisector whose vertical projection has 30º with the R.L. The distance between the intersection points of r with the R.L is
120mm.
vα

hα
UNIVERSIDAD
CARLOS III DE MADRID
Mechanical Engineering Department BASICS IN ORTHOGRAPHIC PROJECTION
ESCUELA POLITÉCNICA SUPERIOR TECHNICAL DRAWING IN ENGINEERING

2. Draw the section of the plane along the cube

vα

hα
UNIVERSIDAD
CARLOS III DE MADRID
Mechanical Engineering Department BASICS IN ORTHOGRAPHIC PROJECTION
ESCUELA POLITÉCNICA SUPERIOR TECHNICAL DRAWING IN ENGINEERING

3. Draw the projections of the line s which is perpendicular on the given line r, through the point A and that cuts the vertical plan at 30
mm of height.

You might also like