Scribd
Upload
170 views1 page

Parallel Flange Channels: Dimensions and Properties AS NZS 3679.1 300

The document provides information about parallel flange channel sections, including their dimensions, properties, and grades according to Australian standards. It notes that 300PLUS sections exceed the minimum requirements of AS/NZS 3679.1-300 and have a tensile strength of 440 MPa, replacing the previous grade 250 in 1994. Grade 350 sections have a higher tensile strength of 480 MPa. Diagrams show the channel section geometry and labels for relevant properties and loads.

Uploaded by

Anirban Bhattacharjee
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
170 views1 page

Parallel Flange Channels: Dimensions and Properties AS NZS 3679.1 300

The document provides information about parallel flange channel sections, including their dimensions, properties, and grades according to Australian standards. It notes that 300PLUS sections exceed the minimum requirements of AS/NZS 3679.1-300 and have a tensile strength of 440 MPa, replacing the previous grade 250 in 1994. Grade 350 sections have a higher tensile strength of 480 MPa. Diagrams show the channel section geometry and labels for relevant properties and loads.

Uploaded by

Anirban Bhattacharjee
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

PARALLEL FLANGE CHANNELS

DIMENSIONS AND PROPERTIES bf - t w y


xo
AS NZS 3679.1 300 tf

tw d1 Load A Load B
d L
x x

r1 Shear
Centre
R
bf tf xL
y

300PLUS

PARALLEL FLANGE CHANNELS


PROPERTIES FOR ASSESSING SECTION CAPACITY
bf - t w y
AS NZS 3679.1 300 tf
xo

tw d1 Load A Load B
d L
x x

r1 Shear
Centre
R
bf tf xL
y

300PLUS AS 3679.1-350

Notes:
1. For 300PLUS sections the tensile strength (fu) is 440 MPa.
2. For grade 350 sections the tensile strength (fu) is 480 MPa.
3. 300PLUS hot-rolled sections are produced to exceed the minimum requirements of AS/NZS 3679.1-300.
4. 300PLUS replaced grade 250 as the base grade for these sections in 1994.

DIMENSIONS AND PROPERTIES HANDBOOK


6

You might also like