Scribd
Upload
77 views

Fragmentation Is An Important Function of Network Layer. It Is Technique in Which

Fragmentation is a network layer technique where gateways break up larger packets into smaller fragments which are then sent independently. Each fragment contains its own header and trailer and can be further fragmented. Reassembly of the fragments is typically done by the destination host, as each fragment acts as an independent datagram. There are two strategies for fragmentation - transparent, where reassembly is done by exit gateways so subsequent networks are unaware of fragmentation, and non-transparent, where each fragment is treated independently and reassembly is done by the destination host.

Uploaded by

Aashu Rajput
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
77 views

Fragmentation Is An Important Function of Network Layer. It Is Technique in Which

Fragmentation is a network layer technique where gateways break up larger packets into smaller fragments which are then sent independently. Each fragment contains its own header and trailer and can be further fragmented. Reassembly of the fragments is typically done by the destination host, as each fragment acts as an independent datagram. There are two strategies for fragmentation - transparent, where reassembly is done by exit gateways so subsequent networks are unaware of fragmentation, and non-transparent, where each fragment is treated independently and reassembly is done by the destination host.

Uploaded by

Aashu Rajput
Copyright
© © All Rights Reserved
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

Fragmentation 

is an important function of network layer. It is technique in which


gateways break up or divide larger packets into smaller ones called fragments. Each
fragment is then sent as a separate internal packet. Each fragment has its separate header
and trailer.
Sometimes, a fragmented datagram also get fragmented when it encounter a network that
handle smaller fragments. Thus, a datagram can be fragmented several times before it
reaches final destination. Reverse process of the fragmentation is difficult. Reassembly of
fragments is usually done by the destination host because each fragment has become an
independent datagram.
For the reference of example of fragmentation you can refer : Fragmentation Example

There are two different strategies for the recombination or we can say reassembly of
fragments : Transparent Fragmentation, and Non-Transparent Fragmentation.
1. Transparent Fragmentation :
This fragmentation is done by one network is made transparent to all other subsequent
networks through which packet will pass. Whenever a large packet arrives at a gateway, it
breaks packet into smaller fragments as shown in the following figure gateway G1 breaks a
packet into smaller fragments.

Figure – Transparent Fragmentation

After this, each fragment is going to address to same exit gateway. Exist gateway of a
network reassembles or recombines all fragments example is shown in the above figure as
exit gateway, G2 of network 1 recombines all fragments created by G1 before passing
them to network 2. Thus, subsequent network is not aware that fragmentation has
occurred. This type of strategy is used by ATM networks . These networks use special
hardware that provides transparent fragmentation of packets.
disadvantages:
 Exit fragment that recombines fragments in a network must known when it has received
all fragments.
 Some fragments chooses different gateways for exit that results in poor performance.
 It adds considerable overhead in repeatedly fragmenting and reassembling large packet.

2. Non-Transparent Fragmentation :
This fragmentation is done by one network is non-transparent to the subsequent networks
through which a packet passes. Packet fragmented by a gateway of a network is not
recombined by exit gateway of same network as shown in the below figure.

Figure – Non-transparent Fragmentation

Once a packet is fragmented, each fragment is treated as original packet. All fragments of
a packet are passed through exit gateway and recombination of these fragments is done at
the destination host.
Disadvantages: Every host has capability of reassembling fragments.
 When a packet is fragmented, fragments should be numbered in such a way that the
original data stream can be reconstructed.
 Total overhead increases due to fragmentation as each fragment must have its own
header.

You might also like