Scribd
Upload
13 views

Netcom Lab Da 4 20bci0115

The document describes setting up HTTP, FTP, DNS and SMTP servers using Cisco Packet Tracer. It details running Packet Tracer, fetching PC and server devices, assigning IPs, connecting devices and simulating a packet between two PCs to test the network.

Uploaded by

Finance IEEE-SSIT
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
13 views

Netcom Lab Da 4 20bci0115

The document describes setting up HTTP, FTP, DNS and SMTP servers using Cisco Packet Tracer. It details running Packet Tracer, fetching PC and server devices, assigning IPs, connecting devices and simulating a packet between two PCs to test the network.

Uploaded by

Finance IEEE-SSIT
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

ASSESSMENT - 4

Name : Devang Garg

Reg. No : 20BCI0115

Slot : L 41+L 42

Subject : NETWORK AND COMMUNICATION (NETCOM- CSE1004)

Faculty : RAJKUMAR R
Q Setup HTTP FTP DNS SMTP Servers using cisco packet tracer

Algorithm

1. Run Cisco Packet Tracer

2. Fetch 6 pc’s from End Devices Section located at the bottom left corner

3. Mark the IP’s for each of the Pc’s

4. Drag 3 switches(2960-224T) to the network , connect 1 st switch to first 2 PC’s and rest accordingly

5. Mark a note of IP’s beside the PC’s

6. Drag 4 Server’s from End Devices located at bottom left corner and define IP’s for the same

7. Connect 1st server to first two PC’s and rest accordingly

8. Drag a packet from menu bar and place it at PC0 and PC1 , simulate it

9. Record Output

Snip Before sending a packet

1|Page
Snip after sending a packet

Output

The packet transfer was successful as shown in the simulation.

2|Page

You might also like