Scribd
Upload
28 views

OUT S

The document provides tutorial questions on electrical engineering topics including DC analysis of a common emitter amplifier circuit, determining voltage gain of an AC equivalent circuit, calculating the resonant frequency and input impedance of a series resonant network, and properties of a series RLC resonant circuit.

Uploaded by

aadarsh khandelwal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
28 views

OUT S

The document provides tutorial questions on electrical engineering topics including DC analysis of a common emitter amplifier circuit, determining voltage gain of an AC equivalent circuit, calculating the resonant frequency and input impedance of a series resonant network, and properties of a series RLC resonant circuit.

Uploaded by

aadarsh khandelwal
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

EE101:Electrical Sciences, Tutorial-12

DEPARTMENT OF ELECTRONICS & ELECTRICAL ENGINEERING


INDIAN INSTITUTE OF TECHNOLOGY GUWAHATI
[Q-1 is for pre-tutorial. Solve it in the space provided and submit at beginning of tutorial]

Name: Roll No.: Tutorial Group:

Q-1. Assuming Si pn junction diodes with a cut-in voltage of 0.7 V, find out the output dc
voltage VOU T in the circuit shown in Fig. Q1. Consider only the case where the peak value of
vs is greater than 1.4 V.

Vs
Rl VOU T

Fig. Q1

1
Basic Electronics

Q-2. A common emitter (CE) amplifier is shown in Fig. Q2. Assume a Si BJT with β = 100.
In Fig. Q2, C∞ represents a large capacitor which acts as a short-circuit for all ac-signals.

10 V 10 V

120 kΩ 4 kΩ C∞

C∞
Vout

Vin

40 kΩ 1.5 kΩ C∞

Fig. Q2 A CE Amplifier

(a) Draw the DC equivalent circuit. Determine all the node voltages and the currents through
all branches.

(b) Draw the AC equivalent circuit and determine the voltage gain. Neglect the collector-to-
emitter resistance.

Frequency Response

Q-3. For the network shown in Fig. Q3,find-


(a) The resonant frequency ω0 ,
(b) Zin (j ω0 )

Fig. Q3

Q-4. A series resonant network consists of 50Ω resistor , 4 mH inductor and a 0.1µF capacitor.
Calculate the values of: (a) ω0 and f0 , (b) Q0 , (c) bandwidth, (d) lower and higher cut off
frequencies (ω1 andω2 ), (e) Zin at ω = 45 krad/s and the ratio of magnitudes of capacitor
impedance to resistor at ω = 45 krad/s.

You might also like