Scribd
Upload
39 views

Manual SIWAREX WP521 WP522 en - PDF Page 135

Uploaded by

Cristi Crse
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
39 views

Manual SIWAREX WP521 WP522 en - PDF Page 135

Uploaded by

Cristi Crse
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Commands

8.3 Command groups of SIWAREX WP521/WP522

Command Command Description


code
715 B Process value Show gross process weight on the main display
716 B process value after first filter Gross process weight after the first filter

Table 8- 4 Commands 1000 ... : Basic functions for weighing commands

Command code Command Description


1001 Set to zero Zeroing (semi-automatic)
1011 Tare Taring (semi-automatic)
1012 Delete tare Delete current tare weight
1013 Valid tare Activate default tare
1016 SIMATIC tare specification Specified tare weight from SIMATIC I/O interface

8.3 Command groups of SIWAREX WP521/WP522


The following commands can be triggered in the scale data block DB_SCALE in the area
CMD1 to CMD3:

Table 8- 5 Command groups of SIWAREX WP521/WP522

Command group Description


1 ... 999 Commands are passed by the function module to the module via data record
DR 2 (scale, weighing, display, trace commands). The meanings of the
commands correspond to the command list (see → Command lists
(Page 133)).
2000 + X Reading of a data record, X corresponds to the data record number.
Example: Data record 3 transmitted by SIWAREX module to SIMATIC CPU
→ 2000 + 3 = command code 2003
4000 + X Writing of a data record, X corresponds to the data record number.
Example: Data record 3 transmitted by SIMATIC CPU to the SIWAREX
module → 4000 + 3 = command code 4003
7001 Read all data - Read all data from the SIWAREX to the CPU
7002 Write all data - Write all data from the CPU to the SIWAREX (service mode
has to be turned on)

Additional information on transmission of commands from the control program by means of


the SIMATIC interface is available in chapter Communication with SIMATIC S7-1500
(Page 137).

SIWAREX WP521/WP522
Manual, 04/2016, A5E36695225A 135

You might also like